- ページ 12

スキャナー Doxie OneのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Doxie One 16 ページ。 Document scanner

Care & Troubleshooting

Lines or dots in scans?

If your scans are showing lines, black dots, or other quality issues, it's time to

clean Doxie. Insert the included cleaning swab into the back of the scanner,

then slowly move the tool back and forth across the entire width of the

paper slot. For an especially dirty Doxie, slightly wet the cleaning swab with

isopropyl alcohol (rubbing alcohol) before use.

Paper jam?

If Doxie gets jammed or stuck, wait until the motor stops, then push the

power button. The paper will be returned to you. Adjust the paper guide,

flatten your sheet, and try again.

Trouble inserting paper?

Be sure to insert sheets firmly with a single motion so Doxie's prefeeder can

grab your paper properly. Hold the sheet until Doxie grabs it. If your paper is

wrinkled or curled and you have trouble inserting it, turn it around, inserting

the bottom first (but still facing up). You can rotate it later on your computer.

Trouble scanning photos?

Use Doxie's included scanning sleeve to protect and scan old or fragile

photos. Be sure to insert the barcode side first when scanning.

Frozen scanner?

Remove power from Doxie to reset – unplug and remove any batteries.

If you're using batteries, recharge them with an external charger – the

charge may be too low for Doxie to operate. Make sure you're using Ni-MH

rechargeable batteries; alkaline or lithium will not work properly.

Scanning while connected via USB?

Don't scan while connected to your computer. Doxie is a stand-alone

scanning appliance and isn't designed for use while connected to your

computer. Only connect Doxie via USB to import scans from the SD card.

Blinking rapidly?

Rapid blinking indicates an error condition.

A. If you were scanning, there's likely a paper jam. Wait until the motor

stops, then push the power button. The paper will be returned to you.

Adjust the paper guide, flatten your sheet, and try again.

B. If you weren't scanning, there's likely a problem with your memory card.

Check to see if it's full, locked, and properly inserted. Clear the card, turn off

Doxie, re-insert the card, and try again.