- ページ 3

配電ユニット Amplink PDMのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amplink PDM 12 ページ。 Power distribution module

Device Overview

Red 10 awg main +12V power wire
Connect directly to the positive pole of the vehicle battery. Always connect the + before
connecting ground. For additional protection, a high amperage fuse (not included) can be added
between the Amplink PDM and the battery. Please contact Rowe Electronics for wire gauge
recommendations when extending this wire.
Black 18 awg internal ground wire
Connect directly to the battery ground or suitable ground point like the ground bus cable included.
Connect the Amplink ground (black) wire after connecting the red + to the battery.
Triggers 20 awg input wires (white-T1, purple-T2, yellow-T3)
Connect 1, 2 or 3 triggers to achieve desired functionality. At least one trigger is required to be
activated in order to wake the Amplink device from sleep. These wires are stamped "TRIGGER1",
"TRIGGER2", "TRIGGER3"
Outputs 14 awg (white, purple, yellow, pink, green, orange)
Connect these output wires to the +12V input wire of the accessory to be powered. Each output is
stamped with "OUTPUT" and the corresponding circuit number.
Always Live 14 awg wire (red with white stripe)
The always live output, stamped "ALWAYS LIVE", allows low amperage battery charging
through the Amplink PDM. Please note: There is no monitoring or protection on this always
live circuit. It should be capped or taped off if not being used.
+ 12 V to battery
always live
ground to battery
output 6
output 5
output 4
trigger 3
output 3
trigger 2
output 2
trigger 1
output 1
Page 3 of 12