- ページ 9

リピーター Amplitec C20M-5B3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amplitec C20M-5B3 13 ページ。 Signal repeater

ページを印刷する

C20M-5B Five Signal Repeater

Item

Auto shut-off Functions

Self-oscillation Elimination

Link Balance Function

Auto screen lights off

Power Supply

Power Consumption

RF Connector

Impedance

Environment Conditions

Humidity

Operating Temperature

Installation Guides

Installation Requirements

1) With stable and independent power supply.

2) No corrosive gas, smoke or liquid leakage.

3) Sun block and cool for device's safe running.

4) Easy for cabling and dissipation, safe and easy for maintenance.

5) Waterproof and under thunder protection.

Installation Tools

No.

Items

Percussion drill

Wrench

Mobile phone

for testing

Multimeter

Screwdriver

Waterproof tape

Installation Steps

The repeater should be installed on a solid and hard plane. The installation steps are as

follows:

1) Find a suitable site according to the installation requirements and dimension of repeater.

2) Drill 4 holes with the percussion drill according to the installation holes. Sizes are 7mm.

The expected sites of the holes are as the following diagram.

Uplink stand-by

Self-oscillation

shutdown

Over input turn-off

Function

Over-heat protection

Quantity

Drill holes on wall, self-provided

Reinforce the interface connection, self-provided

Test installation effectiveness, self-provided

Test voltage and wiring connection, self-provided

Tighten or fasten the device, self-provided

Prevent liquid from leaking into the feeder

A few

interface, self-provided

Uplink

Available

No operation within 3 minutes

DC: 12 V

< 45 W

N-Female

50 ohm

IP 40

< 90 %

0℃ ~ +50℃

Remarks

Downlink