- ページ 7

製氷機 Follett Maestro Plus MCD425ABSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Follett Maestro Plus MCD425ABS 16 ページ。 With ride technology

3.3

Install transport tube

Correct installation

§ Length of run no more than 20 ft (6 m)

§ Tube run continuously from ice machine to

dispenser

§ Insulation on entire run of tube

§ No dips or tight bends

§ Tube secured in place

§ No splices

3.3.1

Additional ice transport tube connection specifications for Vision series ice and beverage

dispensers

Check to make sure bin signal on ice machine control board is switched to 24 V connection.

1. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser.

2. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of

ice transport tube(s) (see drawings below).

3. Verify bin thermostat capillary tube is mounted correctly (see drawings below).

Ice tube retainer bracket

ice tube

Vision • RIDE Technology

Incorrect installation

§ Dips in tube where water can collect

§ Splice or tight bend that restricts ice flow

§ Uninsulated tube that results in wet ice and

potential dispensing problems

1" (26 mm)

ice tube

Maestro Plus

ice tube

retaining

bracket