- ページ 7

録音機器 Advanced MxPro 4のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Advanced MxPro 4 10 ページ。 Shop interface unit
Advanced MxPro 4 にも：マニュアル (8 ページ)

2 Configuration

Programming can also be performed from the PC configuration program.

Shop Interface Input

PC Program Inputs

INPUT A

Panel S/W-1

Panel S/W-2

INPUT B

Panel S/W-3

Panel S/W-4

INPUT C

Panel S/W-5

Panel S/W-6

INPUT D

Panel S/W-7

INPUT E

Panel S/W-8

Input C can be used to detect if a signal from an external source is off, pulsing or on continuous (e.g. to detect

an ALERT or EVAC. signal from an external clean contact). The shop interface will activate the EVAC signal if

the signal stays on for more than 1.3 seconds. If the pulsing rate is very slow, this time period can be extended

to 2.6 seconds by placing jumper J1 in position B.

The example below shows sample text for each of the inputs – the actual device and zone text can be freely

changed to describe from where the input signal is coming for a specific application.

The action only needs setting to fault if monitored inputs are required. If simple switch inputs are required, leave this action as "unused".

www.acornfiresecurity.com

Purpose

Switch Input

Cable Fault

Switch Input

Cable Fault

EVAC Input

ALERT Input

Switch Input

www.acornfiresecurity.com

Settings required at PC

Set Zone, Text & Action

Set Zone, Text & Action=Fault

Set Zone, Text & Action

Set Zone, Text & Action=Fault

Set Zone, Text & Action for EVAC

Set Zone, Text & Action for ALERT

Set Zone, Text & Action