- ページ 5

スピーカー AmpliVox SW227 UHFのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AmpliVox SW227 UHF 6 ページ。 Voice projector powered speakers with internal 16 channel uhf wireless receiver and amplifier

ページを印刷する

WIRELESS SET-UP

S1690T Microphone

Transmitter

PLEASE NOTE: YOU HAVE TWO

SEPARATE TRANSMITTERS. ONE

IS FOR THE SPEAKER AND THE

OTHER IS FOR THE MICROPHONE.

MICROPHONE = S1690T

SPEAKER = S1691T

SW225 INTERNAL WIRELESS MICROPHONE RECEIVER:

Select channel (1-16) on panel (A). Channel number should match

channel number on wireless microphone transmitter. S1690T is the

microphone transmitter. Use supplied screwdriver to select channel

number.

SW225 WIRELESS MICROPHONE TRANSMITTER:

Rotate the Channel Selector Switch (B) on the wireless microphone transmitter to the same channel selected on receiver (

Belt clip on the back of the unit clips the transmitter onto a belt or the transmitter simply can be put into a pocket. Plug the lapel micro-

phone into the Mic Input Jack (C). The microphone can be clipped to a necktie or other clothing, using the supplied clip. The lapel

mic should be placed under the chin, as close to the center of the body as possible. Slide the power ON/OFF switch

position (the LED indicator light will illuminate). If you are on the same channel numbers, the LED light on the panel

S1204 Wireless Speaker Connection

Connect provided cable from the MIC INPUT JACK (C) on the S1691T TRANSMITTER into the LINE OUT JACK (E) on the am-

plifier of the SW225 Voice Projector. On the S1204 Speaker select a wireless channel number that is not the same as on the

SW225 speaker. If you chose Channel 1 on the SW225 receiver / transmitter, choose Channel 10 for the S1204 receiver / transmit-

ter. Keep the Channel numbers far apart to avoid interference between the two.

To Operate:

On both speakers, turn amplifiers on. Slide the wireless microphone switch on panel of both units to "ON". Turn both bodypacks

"ON". RF LED on panel of amplifier will light meaning that it is receiving signal. If RF LED does not light, check channel numbers.

When both RF LED's are on, speak into microphone and rotate "VOLUME" control knobs to obtain desired loudness level.

NOTE:

The wireless frequencies used are not on clear channels and may be used by other devices. If the S1204 speaker receives

interference and if you are unable to use the S1691T transmitter, connect the LINE OUT on the SW225 Voice Projector to the S1204

LINE IN using a 3.5mm mini plug cable. Turn the main volume control on the S1204 speaker completely down and use the

AUXILIARY VOLUME CONTROL to adjust speaker level.

SW225 VOICE PROJECTOR

S1691T Speaker

Transmitter

S1204 WIRELESS SPEAKER

Channel Selector

Top Panel

(D)

to the ON

(A) will light.