- ページ 7

製氷機 Follett UD300R400A/WのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Follett UD300R400A/W 17 ページ。 U300/ud300 series ice and beverage dispensers
Follett UD300R400A/W にも：インストレーション・マニュアル (12 ページ)

ページを印刷する

8. On units with beverage valves, remove nozzles and diffusers from valves, soak for at least 10 minutes in cleaning

Solution A, rinse, sanitize with Solution B and reinstall.

9. For models with integral ice water bath beverage cooling only:

a. Lower Tygon drain tube found on drain connection side of waterbath into PVC waterbath drain and drain ice

water bath.

b. Wash bath interior and components with Solution A, using a bottle brush to clean coils.

c. Reposition Tygon waterbath drain line in UP position.

d. Fill waterbath with Solution A and turn power back on.

e. Allow pump to run for 2 minutes to clean pump and pump lines.

f. Turn power OFF, drain bath and secure tube in UP position.

Putting unit back in service after quarterly cleaning

1. On units with integral beverage cooling, fill ice water bath manually with potable water. Add ice slowly enough to

avoid spillage over top of waterbath.

2. Reassemble components.

3. For manual load units, turn dispenser power switch to ON position and fill unit with approved ice (see caution

statement page 2).

4. For automatic load units, turn bin signal switch(es) and dispenser power switch to ON position and allow storage

area to fill.

5. When dispenser has at least 6" (153mm) of ice in lower storage area, press dispense button or lever to test that

dispenser is functioning properly.

Quarterly cleaning of icemaker system

Units with an icemaker require that icemaker be cleaned at least every three months

or more often if local water conditions dictate. Failure to clean icemaker system will

result in decreased performance and potential damage to icemaker. Refer to Icemaker

Operation and Service Manual for instructions.

Disassembly instructions for periodic cleaning

Dispense chute cover removal

1. Remove dispenser top cover and turn three switches on electrical box OFF.

2. Remove two Phillips head screws from top of black dispense chute cover.

3. Pull chute cover forward and down to remove.

4. On push-button actuated units, disconnect plug on harness.

dispense chute cover

(dispense mechanism

behind cover)

dispense

tower (auger

and auger

tube inside)

dispenser top cover

(electrical box below)

Front view

splash

panel

drain

pan