- ページ 7

ウォーター・ディスペンサー Follett H50T5A/WのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Follett H50T5A/W 13 ページ。 Ice and water dispenser
Follett H50T5A/W にも：操作、サービスおよび部品マニュアル (17 ページ)

ページを印刷する

Installing countertop dispensers with legs accessory

Only models with remote icemakers can be installed on legs. Legs cannot be used with

models equipped with integral icemakers (icemaker in top of cabinet).

1. For units where utilities will exit through back of dispenser, loosen rear-most clamp connecting PVC drain line to

flexible tubing, rotate line 180˚ so unused opening of tee fitting faces up, tighten clamp and cap unused tee opening

with plastic cap provided.

2. Fasten two (2) narrow U-shaped channels to underside of dispenser with four (4) 1/4-20 screws supplied. Channels

should be installed with flanges facing up into bottom of dispenser.

3. Use supplied six (6) 8-32 sheet metal screws to attach larger U-shaped metal filler piece to underside of dispenser

between installed flanges. Knock-out holes in this filler should be toward rear of dispenser.

4. Screw legs to channels and tighten securely.

5. Make final connections.

Note: Electrical connection box can also be accessed through front of dispenser by removing front cover,

black plastic chute cover and stainless splash panel.

6. If unit is equipped with water station accessory, make water connection for water station inside dispenser as

indicated.

7. Proceed with instructions for installing remote icemaker.

Installing countertop dispensers with base stand accessory

To avoid possible tipping and resulting injuries, securely bolt base stand to floor through

flanged legs provided. 1.5" (3.8 mm) clearance required on hinge side of cabinet to allow

door to fully open.

1. Install supplied flanged legs, being sure to seat securely against bottom of base stand.

2. Position base stand in desired location.

3. Adjust legs to level base stand from left to right and front to back.

4. Mark floor for holes that will be drilled to anchor unit.

Steps 5 through 14 required only to reverse door orientation.

5. Lift door off hinge pins.

6. Relocate door hinges by using alternate door holes provided.

7. Remove hinges from base stand.

8. Remove plug from one end of hinges and reinstall plug in opposite end of hinges.

9. Reinstall hinges in threaded holes on opposite side of base stand, countersunk side out.

10. Reposition door on hinges.

11. Remove screws from each of two (2) striker plates.

12. Reinstall striker plates on opposite side of base stand, but do not tighten screws.

13. Close door.

14. Reach inside base from top to align striker plates with magnets and tighten screws to secure.

All units

15. Slide base stand away from its location and drill holes for 1/4" anchoring bolts appropriate to floor material

(anchoring bolts not supplied.)

16. Return base stand to its intended location and anchor base stand through flanged legs into floor with 1/4" bolts.

17. Position dispenser on top of base stand and install supplied spacers between top of base stand and under cage

nuts on bottom of dispenser.

18. Using supplied 1/4" screws, secure dispenser to base stand through top of base stand into cage nuts on bottom of

dispenser.

19. Connect utilities.

20. Refer to installation instructions provided with dispenser and proceed with installation of icemaker.

ICDI220