- ページ 2
産業機器 Comco ProCenter PlusのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Comco ProCenter Plus 2 ページ。
ページを印刷するSet‐up Guide
Connections
• Feed handpiece from blaster into work chamber
• Attach vent hose to back by slipping Quicknut
over hose, working the hose over the nipple,
then hand tighten Quicknut onto fitting.
• Connect clear tubing from air dryer to blaster
inlet air connector
• Connect black tubing from air dryer to inlet air tee fitting
• Connect shop air using a ¼" Industrial Shape Quick‐Disconnect
(customer supplied). Example: Foster 3 Series SG1513 or McMaster
Carr 6536K38
• Connect power source to ProCenter Plus
• Connect blaster power cord to ProCenter Plus
HAND‐
PIECE
HOSE
POWER
CORD
AIR
FROM
DRYER
TO AIR
DRYER
Install Air Dryer
The air dryer unit is preassembled and
only requires mounting to the
ProCenter Plus and connection of air
hoses.
• Locate screw holes and position air
• Raise dryer cartridge to facilitate
• Connect air hoses
Blow‐Off Gun
Clean any powder residue from the part with
a quick blast of air.
• Grasp the gun as shown.
• Apply pressure with your thumb to direct
Warning: ProCenter Plus
outlets are designed to
The more the tip is bent, the greater the
supply power for blasters
volume of air released.
only and should not be
used for operating other
equipment.
Air Pressure Regulators
BLASTER
POWER
There are two air regulator controls on the
CORD
electronics box located on back of the unit.
• Air Purge: regulates flow to the air jets;
VENT
HOSE
SHOP
AIR
• Blow‐Off: sets air pressure on the blow‐off
The air pressure regulators are preset at the
Before you set up and
operate your Comco
factory for reasonable air flow and should
blaster, read and follow
not require adjustment with the demands
the safety instructions in
of normal production.
your Maintenance Manual.
dryer on side of ProCenter Plus
driving screws
a blast of air.
prevents abrasive from accumulating in
front of the work chamber.
Note: There should always be air flowing
out of the air jets
gun