- ページ 17

計測機器 Amprobe MO-100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amprobe MO-100 18 ページ。 Milliohm meter

FUSES REPLACEMENT

The maximum continuous voltage which can be applied across the potential

and current leads is around 10.7V. Applying more than that voltage will

automatically blow their respective fuses.

However, the crowbar trigger can be factory adjusted for your application.

We have specially selected that method to stop damaging the instrument,

should it be misused

There are three fuses:

• Power Supply Fuse

The power supply fuse is situated under the tester. Open the battery

compartment, and replace the fuse with the same type

(0.5 A, >24V, Slow Blow)

• Current Circuit Fuse

Fuse protection is provided on the current terminals. This fuse is situated

under the Printed Circuit Board. To access it, you need to unscrew the

four mounting screws which are holding the font panel. Two os these

screws are located under the foots, and the two others are located inside

the battery compartment.

The fuse is automatically blow by the crowbar, should voltage be

present on the resistance under test. This is to prevent damage to the

instrument. It is indicative of this fuse being blown is the RC Led stays

"on". (HBC, 0.5 A, 250Vac, Slow Blow)

Fuses (0.5A / 250V)