- ページ 9

ディスペンサー Follett 110FB425AのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Follett 110FB425A 17 ページ。 Ice and water dispenser

VENT

8. Connect molded drain tube to evaporator drain pan, purge solenoid and rear drain fitting.

9. Connect dispenser bin signal cable to two-pin receptacle on the ice machine electrical box

connect the three-pin receptacle to the ice machine electrical box

10. On dispensers equipped with water-cooled ice machines, connect condenser water supply and drain

lines to condenser fittings on ice machine.

11. Turn on water supply and check for leaks.

12. Plug dispenser power cord into 15A rated NEMA 5-15 circuit.

13. If dispenser is equipped with SensorSAFE, remove protective plastic coating from dispense sensor

labels.

14. Turn on power and bin signal rocker switches and test operation.

15. Clean ice machine following instructions in Cleaning section.

16. Remove dispenser hopper access lid and clean dispenser according to instructions.

17. Replace front cover and secure with screws. Installation is complete.

ice level control thermostat

CLEANING CUP

ICE

NOZZLE

DRAIN PAN

TO DRAIN CUP

0.75" (19 mm)

RESERVOIR FILL

SOLENOID

WATER

RESERVOIR

➋

Hand bend cap tube

end to approximately

45° as shown

45°

110CT425A/W, 110FB425A/W

WATER SUPPLY

3/8" FPT, 45-90 F (7-32 C)

10-70 PSI (69-483 KPA)

➊

and