- ページ 5
アンプ Advanced Amplifiers AA-1M6G-30のPDF 取扱説明書およびクイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Advanced Amplifiers AA-1M6G-30 9 ページ。 Solid state rf amplifier system
ページを印刷するOPERATING INSTRUCTIONS & GENERAL INFORMATION
INTRODUCTION
Advanced Amplifiers is an amplifier equipment and services company supporting commercial and government
organizations worldwide.
Headquartered in San Diego, California, the company utilizes its global network of resources to effectively serve and
support customer requirements.
As a unique original equipment manufacturer of power amplifiers ranging from 10KHz to 40GHz with various output
power levels for CW & pulse testing applications, we can also fully support custom designs and manufacturing
requirements for both small and large volume procurements. We bring decades of combined experience in the RF field
for numerous applications including and not limited to, EMI/EMC, communications, and various commercial and
industry standards.
With our in-house capabilities and fully equipped testing facilities, Advanced Amplifiers is committed to provide the
best in RF products with industry leading quality and lead times.
INCOMING INSPECTION
Inspect unit for any sign of external damage. Do not use this equipment if there is physical damage or missing parts.
Inspect all front and rear panel connectors for damage. Inspect fans and their airways for any damage or blockings. For
a unit with a digital controller option, the USB and ethernet interface and commands list is in the second part of the
manual.
RF & AC CABLE CONNECTION
RF Input and Output connectors are outlined in the specifications table. Use the standard AC cable that was supplied
by the manufacturer or higher power rating cables than the manual specifies. Refer to the front and rear panel
description page for the location of RF and AC connectors.
For a system with a digital controller option – DO NOT USE OR CONNECT a PoE enabled ethernet switch to a system.
Our digital controller does not support PoE connection and will cause permanent damages to a controller unit.
RF TURN ON PROCEDURE
Connect RF input to an RF Pulse Generator and Gating signal. Connect a suitable load for the power rated and
continuous operation to the output connector. Turn on the AC switch, display will show STANDBY. Optionally, connect
the unit to a digital control Software or Ethernet connection. Set the RF generator to nominal 0dBm and set the desired
frequency in the specified range. Select Gain or ALC and set to the desirable output power level then press the ONLINE
button. Use the front panel LCD gain adjust or the remote function to adjust the output power on the power meter
and the LCD screen to desired levels.
Refer to Appendix-1 for detailed operating instructions of the local and remote controller.
RF TURN OFF PROCEDURE
Decrease the RF drive from the RF generator to below -20dBm and press STANDBY on the LCD or via the control
software. Turn off AC switch on the front panel. Disconnect any unnecessary cable connections.
- Ver. 1.0 – 11-22
5 |
P a g e