- ページ 10

計測機器 Amprobe WT-50のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amprobe WT-50 19 ページ。 Dissolved oxygen water quality meter

Setup

The advanced setup mode lets you customize your meter.

9 parameters are available in this model.

P1.0: Clear memory

P2.0: Select Units

P3.0: Coefficient settings

P4.0: Ready indication

P5.0: Auto power off time

P6.0: Real time clock

P7.0: Beta (membrane temperature coefficient)

P8.0: View Calibration data

P9.0: Reset

To enter SETUP mode, hold down "POWER/SET" for some seconds to turn

on the meter. Press "MODE" or "MEM" to select parameters and press

"MNX/AV/ENTER" (indicates "ENTER" in the following instructions) for

parameter settings. To exit any setting, press CAL/Esc.

Note: P0.0 Print function is not available in this model.

P1.0: Clear memory

In P1.0, press "ENTER" go into P1.1. Select "n"-NO or "y"-YES with

"MODE" or "MEM" (Fig. 3), then press "ENTER" to confirm to clear all

memories or not.

P2.0: Select Units

In P2.0, press "ENTER" to go into P2.1. Select temperature unit °F or °C with

"MODE" or "MEM" and then press "ENTER" to P2.2 for selecting DO

unit in mg/l or ppm. Press "ENTER" again to confirm the unit selection and

return to P2.0.

Fig. 3