- ページ 5

コントローラー DPCAV OracleのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DPCAV Oracle 11 ページ。 Video diversity controller

TART OF

ROGRAMMING

Programming begins by holding down the pushbutton switch while you apply power.

Continue to press the switch until the yellow S

also begin to sound off. When you are ready start programming, release the switch. Now

the fun begins!

Step 1:

This entry is used to set the video mode of your two wireless video receivers. For

example, press once for NTSC video.

Step 2:

This entry is used to control the audio alert that is heard whenever the video

sources are automatically switched. For example, press twice to disable the chirp

noise.

Step 3:

This entry is used to control the low battery alarm beep. For example, press once

to enable the voltage alarm beep.

Step 4:

This entry configures the low voltage alarm threshold. To set the alarm to 6.5V, press six

times. Note: the following step will be used to enter the remaining 0.5V value.

Step 5:

This entry is a companion to Step-4 and is used to enter the one-tenth volt value.

For example, if the desired threshold is 6.5V, press six times at Step-4 and five

times at this step. To enter a ".0" value (i.e., 6.0), do not enter any key presses

(wait a few seconds for the step to end).

Range: 1= NTSC, 2= PAL

Range: 1= On, 2= Off.

Range: 1= On, 2= Off.

Low Battery Voltage (N)

Range: 6 to 13 VDC (in 1 volt increments).

Low Battery Voltage (.n)

Range: 0 to 0.9 VDC (in 0.1 volt increments).

LED is on. The audio buzzer will

TATUS

AGE

Jan-2008