- ページ 5

トランスデューサー Daiichi Electronics FAETT2-92A-33のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Daiichi Electronics FAETT2-92A-33 14 ページ。 Power flow current transducer

1. Features of product

 Complied to JIS C 1111：2019 and IEC 60688：2012

 Free power supply specifications compatible with 80 to 264 VAC and 80 to 264 VDC, and 24 VDC/48 VDC

power supply specifications are available.

 Power consumption and mass are reduced by approximately 50% compared to our conventional products, and

miniaturization has also been achieved.

 Compatible with two types of mounting methods for IEC/DIN rail mounting and wall mounting.

Please refer to the wiring diagram for the terminal arrangement.

MAX. adjustment VR

(With VR cap)

BIAS adjustment VR

(With VR cap)

１

Note(

) Dimensions when IEC/DIN rail (height 15mm) is installed. (Please use a rail with a width of 35mm)

The terminal cover is standard equipment.

① Inspection certificate ：1 (Packed in an envelope)

② Terminal screw in a bag. M4 screw 10-piece set：1

Please install indoors in a place with low mechanical vibration, dust, and corrosive gas.

And, please select indoors that are not affected by a strong electromagnetic field by large current bus,

saturable reactor etc. in the vicinity. There is no restriction on mounting position.

Mounting can be done on 35mm width DIN rail mounting or screw mounting.

For screw mounting, please install with M4 screw or M5 screw. (However, the screw is not attached.

The tightening torque of a screw, M4：1.00 to 1.30N･m, M5：2.0 to 2.5N･m)

There is no particular rule for the side-by-side spacing.

Considering heat dissipation and wiring space, please leave 90mm or more space between the top and bottom.

Please leave space between terminal and metal panel for 10mm or more.

<Caution> Be sure to turn off the power and input signals before installing or removing the product to

prevent danger.

10-M4screw

130

Terminal cover

Q-222-030

(12.5)