- ページ 7

高圧洗浄機 Foma 840のPDF 操作説明をオンラインで閲覧またはダウンロードできます。Foma 840 9 ページ。 Wall high pressure cold water cleaner

ページを印刷する

It is advisable to point out the correspondence of the

holes: remove the machine from the bracket and

make the holes in such a way as to conveniently

work with the drill.

After definitely fixing the machine to the wall, intro-

duce the high pressure pipe into the loop under the

pipe winding device (Fig. 5); then fix the holder

bracket for accessoiries as shown in fig. 6.

Connect the high pressure pipe (previously released)

to the gun and make sure that the safety device is

locked (Fig. 7-A).

4 4 4 4 4

CONNECTION OF THE WATER SUPPLY

PIPE

Connect a clean water supply pipe (Fig. 9

– pos.3) to the water mains, checking to

ensure that the minimum pressure is of 1.5

bar and maximum is of 6 bar, with a

minimum flow rate of 6 l per min.

Connect the water supply pipe (min. diam ½") to

the water mains (fig.8)

Fit the click-on attachment (Fig. 9 - pos.1-3) onto

the fitting (2);

5 5 5 5 5

ASSEMBLY OF THE DETERGENT

SPRAYING DEVICE (Fig.10)

Insert the sprayer pipe into the spray gun

Rotate the pipe by 90°, and on extracting it, click it in.

6 6 6 6 6

ELECTRICAL CONNECTION OF THE

APPLIANCE

The mains voltage must match the operating voltage.

(See identification plate)

Insert the plug into a power socket installed in

compliance with regulations.

Check the minimum section of the individual cables

using extensions.

Position the extensions so as to maintain the protection

class of the equipment.

Voltage V

Cable

length

230

up to 2

230

20 to 5

7 7 7 7 7

8 8 8 8 8

9 9 9 9 9

The nozzle with rotating head can be rotated in a

continuous manner, by moving the terminal part.

ADDITION OF DETERGENT

Cross-section

mmm2

1,5

2,5

APPLIANCE ACTIVATION

Press button I (Fig.11-ON) on the main switch

positioned at the rear of the device

Position the spray gun on the object to

be cleaned - never on people !

Press the safety device (Fig. 12 - pos. 1) - the gun

is released

Direct the nozzle downwards

Fully press down the trigger (Fig. 12 - pos. 2)

SWITCHING OFF THE MACHINE

Press the button marked with an 0 0 0 0 0 on the switch

(Fig. 11- OFF

OFF

OFF)

OFF

Turn off water supply tap.

Actuate spray gun until water drips from the

nozzle (machine is now de-pressurized).

Release trigger.

Press safety latch on spray gun. (Fig.13- pos.1).

The spray gun is locked and cannot be actuated

accidentally.

Unplug machine from socket outlet.

Disconnect water supply hose from machine and

water supply mains.

EQUIPMENT

The detergents must not be

allowed to dry on the object to

be cleaned.

Push the sprayer pipe towards the gun, turning it

by 90° and then extract it (Fig. 14)

Apply the detergent spray kit to the gun (Fig. 15).

Fill the container of the spray kit with suitable

detergent (see paragraph "General safety

recommendations" in this booklet).