- ページ 3
コントローラー Amptone Lab MIDI StripのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amptone Lab MIDI Strip 4 ページ。 Midi controller kit for electric guitar
ページを印刷するSETUP AND USAGE
For a direct connection between MIDI Strip and the
controlled device, you need to use a standard MIDI cable
(DIN5). You can connect it to any MIDI device which
reponds to MIDI Strip messages (see the MIDI table below).
HOLD MODE:
The pushbutton activates controller's
Hold mode. When hold mode is active, MIDI Strip will
not be sending messages related with touch action.
REVERSE MODE:
If you are not happy with the
minimum and maximum positions on the touch strip,
it is possible to reverse their positioning. To activate
or deactivate reverse mode, hold the MIDI Strip
pushbutton while starting it up.
Mode
Default devices
1
Korg KP2, KP3, KP3+,
Kaossilator Pro,
Kaossilator Pro+
2
DigiTech Whammy 4,
Whammy 5, Whammy
DT, Bass Whammy
3
MIDI hardware
synthesizers, MIDI
software synthesizers
4
MIDI drum machines,
MIDI drum samplers,
MIDI drum synthesizers
MIDI ch.
Touch strip
1
MIDI CC12 (0-127)
MIDI CC13 (0-127)
2
MIDI CC10 (0-127)
MIDI CC11 (0-127)
3
Note On, Note Off
MIDI notes range: 60-71 (C4-B4)
Notes velocity: 100
10
Note On, Note Off
MIDI notes: 36, 38, 46, 49 (bass
drum, snare, open hi-hat, crash)
Notes velocity: 100
SWITCHING PROGRAMS:
switch between programs of the controlled device. To
do so, you need to twist the rotary encoder. MIDI Strip
sends Program Change messages within 0-127 range.
SWITCHING MODES:
controller modes, each sending different MIDI message
set (see the MIDI table below). To switch between
modes, press and hold the rotary encoder for 1 second.
Mode will be indicated by the number of LED flashes.
COMPATIBILITY:
MIDI Strip uses default settings of
devices used in modes 1 and 2. You may, however, need
to reset the device's MIDI channel. Please refer to this
device's manual to find out how to set the MIDI channel.
Touch event
MIDI CC92
(0; 127)
MIDI CC0
(0; 127)
MIDI CC14
(0; 127)
MIDI CC15
(0; 127)
MIDI Strip allows you to
MIDI Strip offers 4 different
Rotary encoder
Program Change
(0-127)
Program Change
(0-127)
Program Change
(0-127)
Program Change
(0-127)