- ページ 4

コントローラー DPS Turbonator VGTのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DPS Turbonator VGT 13 ページ。

1. The harness is very simple to understand and connect.
2. Lay the cords out on a floor and simply connect the same color to the same color
connector, (grey to grey) of the same type connector.
3. Attach battery power as follows: BLACK ring to ground and the RED to Positive
terminals of the battery.
4. Attach the ACC wire to your accessories power (usually in your fuse panel).
5. Pull the toggle switch and USB cables into the cab, through the firewall.
6. Plug in the sensor wires (PURPLE=Boost Sensor / YELLOW=Exhaust Sensor).
7. Plug in the Actuator wire to the actuator. Make sure actuator wire is securely fastened
(DO NOT BUMP OR BEND THE ACTUATOR, MISALIGNMENT CAN OCCUR).
8. Note: DO NOT LOOSEN OR ADJUST THE ACTUATOR FROM THE HOUSING. It is
configured to the housing it comes on. If you to need to reconfigure the actuator please
call us at (801)930-8404.
9. Software can be downloaded from our Website
https://www.dieselpowersource.com/installation-instructions#
Software) which can tune and control the actuator, but the control is pre-programmed
from DPS, and is not required to connect to a computer to operate properly.
Note 1: The harness can be cut the harness, to ensure proper fitment.
Note 1: If any part of the harness is shortened. The wires must be soldered, and heat shrunk.
Caution 1: Take caution when cutting the harness. There may be 2 or more wires side by side
with the same color code with different functions.
Caution 2: Only cut one branch at a time, once that branch is completed then move to another.
Cutting more than one branch may cause issues identifying how the branches connected.
Revision 1.3
Revision Date 1/28/2020
www.dieselpowersource.com
Wiring Harness (Cont.)
Turbonator® VGT Controller
(choose "DPS Turbonator®