- ページ 6

室内装飾品 AMQ ACTIV-ProのPDF ユーザー＆トラブルシューティングマニュアルをオンラインで閲覧またはダウンロードできます。AMQ ACTIV-Pro 12 ページ。 Sit-to-stand table
AMQ ACTIV-Pro にも：インストレーション・マニュアル (12 ページ), ユーザーマニュアル (7 ページ), 組立マニュアル (16 ページ)

ページを印刷する

User Guide

Programming Memory Presets

1 .

Press the up or down arrow to set the worksurface to the desired height .

2 . Press "M" button followed by one of the preset number buttons (1, 2 or 3) on the LED screen .

3 . The table will automatically reset to this height whenever the preset number is pressed and

preset height is reached .

Power Saving Mode - Waking up the Hand Set

1 .

Press any button to wake up handset .

Resetting the Base

Note:

Make sure there is nothing under the base before setting to its lowest level (24 .5") .

If the cable is obstructed it will not reset properly .

1 .

Press and hold the Down arrow; the desk will begin to go down .

2 . Once the desk reaches its lowest height, continue to press the Down arrow for 5 seconds, until the digital

display shows "RST" .

3 . Release and then press the Down arrow again; the recalibration process will now begin .

4 . When reset is complete, the digital display will show "24 .5" .

Hard Reset for E07/E08 (If base is half way or full standing position)

1 .

Press on the down button and hold until you see ASR code and release .

2 . Immediately after releasing down button, press and hold down button again, the base will slowly go down .

3 . Hold the down button until the base hits bottom, keep holding down button and wait for the base to bump up .

4 . Release when you see height numbers . Your base is reset .

*Previous versions of ACTIV have "press and go" technology and don't require the hold of a button to reach

pre-programmed heights .

Activ-Pro User / Troubleshooting Guide | 6

A . Height Adjustment Buttons

B . Memory Position Buttons

C . Memory Setting Button

D . Digital Display

held*

until the

amqsolutions.com