- ページ 4
タッチターミナル DPS Telecom D-PG-413-11C-00のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DPS Telecom D-PG-413-11C-00 11 ページ。 Digital base terminal package consists of blank card and dvf-64 digital interface card
ページを印刷する19" or 23" Rack/
5" Projection
19" or 23" Rack/
Flush Front
19" or 23" Rack/
5-1/2" Projection
19" or 23" Rack/
1/2" Projection
NOTE: Use wide ears for 23"
Fig. 4 - Position mounting ears for desired projection.
Installation
NOTE: The shelf fits in either a 19" or 23" rack. The mount-
ing brackets on the side of the unit can be positioned for ei-
ther 5" projection or flush mounting in a 19" rack or for
5-1/2" projection or 1/2" projection in a 23" rack.
1. Determine which mounting configuration is required and
orient the mounting brackets as shown in Fig. 4.
NOTE: Longer brackets are provided for 23" racks.
2. Attach each bracket with two 6-32 screws (provided in
hardware bag).
Press switch down to turn off
1
2
4
3
J32 - J35
Default = Closed
Fig. 5 - Set S2 and Terminal / Repeater switch on the DVF-64 card.
UM118129
SIDE VIEW
Sw 2
Terminal
Repeater
3. Place the shelf in the rack and align the mounting holes in
the brackets with the holes in the rack rails. Secure each
bracket with two 10-24 screws (provided in hardware bag).
NOTE: A wire-wrap tool with an .060" mandrel is required.
Refer to the wire wrap pin layout drawing (Fig. 8) for all
wire-wrap pin designations.
NOTE: The expansion card slot is factory wired for the
DVF-64 Digital Polling Channel.
4. Connect Fuse Alarm contacts to alarm device, if required.
(Refer to Fig. 8.)
5. Connect DB15 cables to the Network A and Network B
REAR
connectors on the back of the shelf.
6. Connect other end of cables to appropriate connector on
the fiber terminal. See Fig. 8 and Table B for DB15 pin-outs.
NOTE: Cable lengths are specified as 50', 75' or 100' when
the shelf is ordered. If lengths are incorrect, contact DPS in-
side sales to order the correct lengths.
7. Remove fuses from DVF-64 front panel.
8. Connect power at power barrier terminals. Refer to Fig. 8.
NOTE: Observe polarity of power connections. "Battery"
terminal is negative on -24 and -48 volt models.
NOTE: Do not replace fuses until board options are checked
and adjusted.
9. Remove DVF-64 p.c. board.
10. Set SW-1, Terminal/Repeater switch. Refer to Fig. 5.
(Continued on page 10)
Application
End point, Section A
End point, Section B
Mid point (repeater),
E2A looping
Mid point,
E2A non-looping
J23, J24, J29
Default = Open
Sw 1
J- Closed
4
Table C - DVF-64 Switch Settings
SW2-1
SW2-2
SW2-3
SW1
Term.
ON
OFF
OFF
OFF
Term.
OFF
ON
Rptr.
ON
ON
ON
Term.
ON
ON
OFF
J22
Default=OSC1
J- Open
D-PG-423-11C-04
August 11, 1999
SW2-4
OFF
OFF
OFF
OFF