- ページ 15

キャッシュカウンター＆コインソーター Amrotec CC-03のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amrotec CC-03 19 ページ。 Coin counter heavy-duty with conveyor

ページを印刷する

9. Troubleshooting

In case of an error event, the CC-03 stops and shows an error message. The messages and locations

are explained below. When the error is solved, confirm the message and press On/Off to count further.

When the error appears repeatedly and you cannot fix that problem, please call the service and tell

them the error message.

Pos

Error code

Are you sure

you want to

proceed?

B1 (or 2) stop

Coin under

sensor

Enter denom.

value before

Motor does not

start (w/o error

message)

Please empty

the bag

Press "M" to

save

Side cover

open

To activate,

count and bag

will cleared

Transport jam

Value overflow.

Clear counter.

Coin feeder

does not start

Error locations:

Error description

When selecting another

coin number or denom.,

the current count and bag

content will deleted.

The pre-set bag stop for

the current coin number/

denomination is reached.

There are coins or foreign

bodies jam under the coin

counting sensor

There is no value

configured for the

selected denomination

The total memory is

selected.

When clearing the count

result, also the bag

content will set to zero.

To confirm and activate

the new setting.

The right top cover is not

closed.

A new bag stop was

selected but the counters

weren't zero.

The coin transport does

not operate. Coins or

foreign bodies jamming

on the disc or under the

transport belt.

The counted value or

memory does exceed the

maximum (99,999.99)

The disc full sensor is

blocked.

Removal

Press "1" (Yes) to change the denomination and

delete the current count and coins in bag.

Press "2" (No) to cancel the operation and count

further or save the current denom.

Replace the bag. Press START or the Quick-

change switch to count further.

Note: The complete count is automatically saved in

the memory and the bag counter is set to zero.

Open the right top cover. Lift up the transport belt.

Clean the count sensor and remove jammed

objects. Control the coin diameter setting.

Select another denomination or enter a value in the

"Deno/ Batch setting" menu.

Select a denomination with the "1" key.

Empty the bag. Press START or the Quick-change

switch to repeat the count.

Press "M" to confirm and activate the new setting.

Close the cover.

Press "1" to clear the count and bag content.

Press "2" to cancel. The stop before is still active.

Open the right top cover. Lift up the transport belt.

Remove jammed objects. Control the coin diameter

and thickness setting.

Check that the motor switch is activated when the

right top cover is closed.

Print (if available) and then clear the counter or

memory.

Check and remove the disc full sensor

15 of 17