- ページ 2
レシーバー Advanced Bionics Naida CIのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Advanced Bionics Naida CI 2 ページ。
Advanced Bionics Naida CI にも： 操作マニュアル (2 ページ)
ページを印刷する
DEVICE DESCRPITION
The TV Connector allows you to connect your Naida CI Q90 sound processor via the Naida CI Connect
and Phonak direct connectivity wireless hearing aids to your TV or other entertainment/communication
devices. The TV Connector sends audio signals within a 15 meter (50 ft) radius wirelessly to your
processor or hearing aids.
CONNECTING THE TV CONNECTOR
TO A PROCESSOR OR HEARING AID
1
Press the Connect
and the indicator light will start blinking blue.
Ensure the processor or compatible hearing
2
aid is witched on and within 1 meter (3 ft) of
the TV Connector.
A confirmation beep will play with the
3
connection is successful. This may take up to
10 seconds.
If no audio is present during the connect
4
process, ,beeps will be played left/right during
5 seconds after the confirmation beep of the
hearing aids.
TIP
A long press on the Naida CI Connect button will
mute the signal from the TV Connector. Another
long press on the Naida CI Connect button will
unmute the signal. You will hear a beep to
confirm the signal has been muted or unmuted.
DAILY USE OF THE TV CONNECTOR
1
Switch on the TV (or alternative audio
device). If the TV Connector is powered on, it
will automatically transmit the audio signal to
the connected processor or hearing aid.
To adjust the volume of the audio from the TV
2
Connector:
• Push the volume increase (+) or decrease
(-) button on top of the TV Connector.
TIP
If no audio input is available, the TV Connector
automatically stops the audio transmission. The
indicator light will be solid white (standby mode).
button on the back,
TV Connector
TV CONNECTOR AND PHONE CALLS
1
If the hearing aids are connected to your cell
phone, you can still receive phone calls, even
when using the TV Connector.
In case of an incoming call, the processor or
2
hearing aid will automatically stop the audio
signal from the TV Connector and alerts will be
played signalizing the incoming call. After the
call, it automatically switches back to the TV
Connector audio signal.
TV CONNECTOR AND PHONE CALLS
1
To end transmission of the audio signal, switch
off the TV or other connected audio sources. The
TV Connector will go into standby mode
automatically.
2
You can also turn off the TV Connector using the
power button on the top of the device. When
using the TV connector the next time, turn it on
by pressing the power button.
TIP
Line-of-sight between your hearing aids and the
TV Connector is not required. However,
environmental interference like walls or furniture
may reduce the operating range.
LED
Solid Green
Indicator
Solid White
Blinking blue
Blinking Red
No light
QUICK GUIDE
Switched on and
transmitting audio
Standby mode
Connecting mode
Wrong audio input
format
Switched off