- ページ 5

自動販売機 AIRSLED VM2401のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AIRSLED VM2401 9 ページ。 Vending mover
AIRSLED VM2401 にも：オーナーズマニュアル (9 ページ)

ページを印刷する

GOING OVER POROUS SURFACES SUCH AS CARPETING

All Airsled systems come with plastic Rough Surface Adapters (RSAs). The RSAs are 10" wide x 36" long

and laid on top of the porous surface. The air beams MUST BE PLACED OVER THE RSAs in order for

your system to perform properly. See figure 9. Your system comes with 4 RSAs allowing you to create a

short track to move the load. If moving the load over long distances, heavy carboard paper such as Ram

Board

floor protection can be used. See figure 10.

Figure 9

CARE AND MAINTENANCE

Airsled systems are proudly made in the USA using the highest quality materials. If properly used and maintained,

your Airsled product will have a long service life. To ensure optimal performance and longevity, we recommend the

following:

•

Keep the edges of the air beams from striking hard objects.

•

When moving or repositioning the air beams, avoid dragging the corners.

•

Avoid lifting and carrying the air beams by the inlets. Carrying the air beams by only the inlets may

cause them to come loose over time.

•

Periodically inspect the blower filter and bag depending on model. These components should be

cleaned to ensure peak performance of the system's blower.

•

Check the rubber fabric for rips and dirt. If dirty, water with a mild detergent can be used to clean

them as well as household cleaning sprays such as Windex

Armor All

is recommended.

•

If you find any rips in the fabric, please see the Repairs and Refurbishment section.

REPAIRS AND REFURBISHMENT

Wear and tear over time especially with frequent use may cause components to fail. Airsled offers

refurbishment services that can restore your aluminum air beams to as-new condition. More information

can be found on www.Airsled.com. Due to safety and regulatory concerns, Airsled cannot refurbish the

blower. Airsled also sells replacement parts. Please see detailed parts list in Exhibit 1. Any repairs

performed by the end-user should be considered temporary. We recommend contacting Airsled to

determine the proper course of action based on the nature of the issue. Some common, temporary

repairs that can be performed in the field include:

Rips in the rubber fabric. Small rips can be temporarily repaired with duct or electrical tape. Before

applying tape, the area must be cleaned and dried. We recommend returning your air beams to

Airsled to be fully refurbished if rips are discovered.

. To restore the rubber fabric's shine,

70 – A Aleph Dr.

Newark, DE 19702

Page 4 of 8

Figure 10

Support Email:

[email protected]

Toll Free Number: 1-800-AIRSLED (1-800-247-7533)