- ページ 15

冷蔵庫 Electrolux Built-In DishwasherのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Electrolux Built-In Dishwasher 28 ページ。 Built-in oven
Electrolux Built-In Dishwasher にも：取扱説明書 (36 ページ), 取扱説明書 (44 ページ), 取扱説明書 (28 ページ), 取扱説明書 (40 ページ), 取扱説明書 (27 ページ), 取扱説明書 (12 ページ), 取扱説明書 (22 ページ), ヒントとレシピ (36 ページ), 取扱説明書 (18 ページ), オーナーズマニュアル (21 ページ), オーナーズマニュアル (13 ページ), オーナーズマニュアル (29 ページ), ユーザーマニュアル (27 ページ), 取扱説明書 (17 ページ), 取扱説明書 (15 ページ), インストラクションブック (18 ページ), 取扱説明書 (27 ページ), 取扱説明書 (18 ページ), サービスマニュアル (50 ページ)

Finishing the Connections

NOTE

If you are using an existing water line, cut 1" off the end. Always use a new ferrule and

compression nut.

1. Flush the water supply line to clear any foreign material before

2. Make sure that there are no sharp bends or kinks to restrict the water

3. Insert the water line into the 90° elbow. See Figure 15.

4. Slide the ferrule against the elbow and secure with the

5. Turn the water on to check for leaks.

6. Feed the dishwasher cable through the small hole in the junction box.

7. Replace the access cover.

NOTE

Follow all local codes and ordinances.

The dishwasher is supplied with a 72" long drain hose.

1. If a longer drain hose is required, add up to 48" of length for a total of 10 feet.

The hose must not restrict the ﬂow from the drain of the dishwasher to the

house's drain system. The type of hose used should be consistent with the

type and diameter installed on the dishwasher.

2. Secure the drain hose to the air gap, water tee or disposer with clamps.

3. Make sure the drain hose is not kinked.

connecting to the dishwasher.

ﬂow.

compression nut.

NOTE

When connecting the drain line to the disposer, check to be sure

that the knockout plug has been removed. DISHWASHER WILL NOT

DRAIN IF THE PLUG IS LEFT IN PLACE.