- ページ 8

食器洗い機 Bosch 2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch 2 8 ページ。 Mini blender
Bosch 2 にも： クイック・インストール・マニュアル (16 ページ), 設置・使用マニュアル (18 ページ), オリジナル取扱説明書 (13 ページ), オリジナル取扱説明書 (22 ページ), 取扱説明書 (32 ページ), ユーザーマニュアル (28 ページ), ユーザーマニュアルと設置手順 (16 ページ), 取扱説明書 (42 ページ), 取扱説明書 (8 ページ), 取扱説明書 (12 ページ), クイック・スタート・マニュアル (2 ページ), クイック・スタート・マニュアル (9 ページ), 取扱説明書および取付説明書 (36 ページ), ユーザーマニュアルと設置手順 (48 ページ), 取扱説明書 (26 ページ), クイック・リファレンス・マニュアル (2 ページ), ユーザーマニュアルと設置手順 (24 ページ), 取扱説明書 (42 ページ), ご利用案内 (28 ページ), ユーザーマニュアル (40 ページ), ユーザーマニュアルと設置手順 (35 ページ), ユーザーマニュアル (24 ページ)

ページを印刷する
Bosch 2 取扱説明書
What to do if...
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.

– Start/Pause

Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Programme stopped?
cannot be opened.
– - - - - (Rinse stop = no final spin) selected?
Programme does not start. – Start/Pause
– Washing machine door closed?
– Childproof lock active? Deactivating
Detergent solution is not
– - - - - (Rinse stop = no final spin) selected?
drained.
– Clean the detergent solution pump
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Spin result not satisfactory.
– Not a fault - the imbalance monitoring system has interrupted the spin
Laundry wet/too damp.
because the laundry is unevenly distributed.
Distribute large and small items of laundry evenly in the drum.
– Speed selected too low?
The programme duration
– Not a fault - the programme cycle is optimised for the particular
changes during the wash
washing process. This can cause changes in the programme duration
cycle.
on the display panel.
Spin cycle performed
– Not a fault - unbalanced-load detection system is adjusting the
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary
products.
Odour formation in the
– Run programme
washing machine.
detergent.
Status display
flashing.
– Too much detergent used?
Appliance has detected a
Mix one tablespoonful of fabric softener with ½ litre water and pour
detergent overload.
into compartment II (Not for outdoor fabrics, sportswear fabrics or
those made with down.)
–
Reduce the detergent dosage for the next wash cycle
Loud noises, vibrations and
– Are the appliance feet fixed?
"wandering" during the
Secure appliance feet
spin cycle.
– Transportation safety devices removed?
Remove transportation safety devices
Display panel/indicator
– Power cut?
lamps do not function
– Circuit breakers tripped? Switch the circuit breakers back on or
during operation.
replace.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence
– Not a fault - unbalanced-load detection system is adjusting the
longer than usual.
imbalance by repeatedly redistributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse
cycle.
There are detergent
– Occasionally, phosphate-free detergents contain water-insoluble
residues on the laundry.
residues.
– Select Rinse
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service
not selected?
page 11.
page 4.
page 3,4.
or Ready in
time selected?
page 5.
page 3, 4.
page 11.
page 5.
page 10.
Cottons 90 °C without laundry. Use standard
.
Installation instructions.
Installation instructions.
or brush down the laundry after washing.
Installation instructions.
Washing machine
WAB20267IN
en operating instructions
11