WARNING ‒ Risk of burns!
The appliance becomes hot during operation.
Allow the appliance to cool down before cleaning.
▶
Requirement: The appliance is switched off.
Clean the appliance with a damp cloth and a neutral
1.
cleaning agent, such as washing-up liquid and wa-
ter.
Dry with a soft cloth.
2.
16.3 Cleaning the stainless steel surfaces
Always remove limescale, grease, starch or albumin
1.
stains immediately.
Corrosion may form under such stains.
Clean with water and some washing-up liquid.
2.
Dry with a soft cloth.
3.
16.4 Cleaning the glass front
Clean the glass front using a glass cleaning product
▶
and a soft cloth.
17 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
17.2 Malfunctions
Fault
The appliance is not
working.
The appliance is
switched on. The op-
eration indicator does
not light up.
Cause and troubleshooting
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
1.
Open the appliance.
Following a power cut, the touch fields light up in ascending order from left to right.
The display goes out after approx. 30 seconds and the appliance is ready for operation.
2.
Start the required operating mode.
The operation indicator is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 15
Do not use any abrasive sponges that may
‒
scratch or any glass scrapers.
16.5 Cleaning the glass plate
1.
Clean the glass plate using a glass cleaning
product and a soft cloth.
Do not use any abrasive sponges that may
‒
scratch or any glass scrapers.
Dry with a soft cloth.
2.
16.6 Cleaning the control panel
Clean the control panel with a damp cloth and neut-
1.
ral cleaning agent, such as washing-up liquid and
water.
Do not use any abrasive sponges that may
‒
scratch or any glass scrapers.
Dry with a soft cloth.
2.
17.1 Fault indicator
In the event of a fault, the operation indicator flashes
quickly. A signal tone sounds. When you open the ap-
pliance, symbols light up on the control panel, depend-
ing on the cause.
Touch any touch field to switch off the signal tone. If
you then touch
, the display goes out.
Troubleshooting en
13
ページを印刷する