- ページ 10

食器洗い機 Bosch Ascenta SHE4AM12UのPDF 修理指示をオンラインで閲覧またはダウンロードできます。Bosch Ascenta SHE4AM12U 50 ページ。
Bosch Ascenta SHE4AM12U にも：修理指導 (27 ページ)

COMPONENTS

4.1

Ascenta dishwashers have two control modules, a control module

(with display, lights & buttons) in the fascia (control) panel and a

power module in the base on the right side. The power module

controls the BLDC drain pump and heat pump.

The wire harness connected to the control module can either be a

separate harness or the 1-piece dishwasher harness, depending

on when the dishwasher was built. The wiring is the same, with

the only difference being whether the dishwasher has three

harnesses or one harness.

702_58300000130262_ara_en_c

1. Control module (in fascia panel)

2. Power module (in base)

4.2

The door latch is mounted on top of the tank and doesn't contain

a microswitch. It uses a Hall-effect sensor in the door to sense

the door latch magnet to determine if the door is open or closed.

The Hall-effect sensor is held by two T-10 Torx screws. The door

latch is held by one T-20 Torx screw and two tank tabs.

1. Door latch

2. Hall effect sensor

Starting FD8907, the small door latch face plate has been

integrated into the tray insert (and can't be obtained separately).

1. Newer integrated face plate

2. Older separate face plate

Page 10 of 50