- ページ 28

食器洗い機 Bosch Ascenta SHE4AM12UのPDF 修理指示をオンラインで閲覧またはダウンロードできます。Bosch Ascenta SHE4AM12U 50 ページ。
Bosch Ascenta SHE4AM12U にも：修理指導 (27 ページ)

5. Carefully push the dispenser in through the inner door (i.e.

toward the dishwasher tank).

CAUTION: Inner door edges are sharp! Cover door edges

and remove dispenser carefully.

5.3.2

To install dispensers

1. Where necessary, bend back inner door flanges so they

can snap into dispenser tabs.

2. To aid installation, coat dispenser seal with rinse-aid.

3. Carefully push the dispenser out through the inner door

(i.e. from inside the dishwasher toward the front of the

dishwasher).

4. Snap inner door flanges onto or into dispenser tabs.

5. Replace cable guide.

6. Reconnect dispenser wire harnesses.

7. Replace outer door.

702_58300000130262_ara_en_c

5.4

Door latches

The door latch is mounted on top of the tank and contains a

magnet, not a microswitch.

senses the magnet when the door or closed.

Confirm whether the latch is misaligned before replacing the latch

or sensor. Check the sensor with a magnet to confirm if it's

properly sensing the latch (see section 6.3.1.1).

5.4.1

To remove door latch Hall Effect sensor

Tools required: T10 Torx, T20 Torx & flat blade screwdrivers.

1. Remove outer door – section 5.1.2.1.

2. Remove fascia panel -- section 5.1.2.2.

3. Disconnect wire harness from sensor (below left).

4. To remove sensor, open door and remove (2) T-10 Torx

screws from the top center of the door (below center).

HINT: When replacing a door latch, make sure the door latch

is aligned and the sensor detects the door latch magnet.

A Hall-effect sensor in the door

Page 28 of 50