- ページ 47

食器洗い機 Bosch Ascenta SHE5AM02UCのPDF 修理指示をオンラインで閲覧またはダウンロードできます。Bosch Ascenta SHE5AM02UC 50 ページ。 Quick reference instructions
Bosch Ascenta SHE5AM02UC にも：取付説明書 (21 ページ), エネルギー・マニュアル (2 ページ), スタート (2 ページ), 修理指導 (27 ページ)

ページを印刷する

DW Symptoms

Error Code Display

(seen

during wash cycles)

Water doesn't fill & drain

pump runs (cont)

Aqua sensor doesn't run

E:28

during wash cycle

properly calibrated

No power

House wiring isn't 120V

Open "On/Off"

switch

Dispenser not operating

Detergent

jammed

connections

Rinse-aid LED is glowing

No rinse-aid

connections

702_58300000130262_ara_en_c

Error Code LED's --

(from cs

Active / Clean / Sanitized

test program)

aqua

sensor

not

"Start"

dispenser

door

loose

wiring

loose wiring

Solution

Make sure water inlet valve isn't stuck "open".

Check float switch and wire harness (to power module).

Check continuity between aqua sensor (I4) and power module harness

connector.

Make sure aqua sensor is clean where it enters the sump.

If electrical connections are good and the aqua sensor is clean, replace

the aqua sensor.

Check house wiring connections and if supply voltage is ≈ 98 - 120VAC

to power module harness connector.

Check "On/Off" switch & power module connections.

Measure "On/Off" switch resistance. If it's '∞' Ω in "on" position, replace

it.

If only drain pump is running, check if float switch has operated (see

E:15 error code above).

If no LED's flash when "On/Off" switch is pressed and the dishwasher

door is open, replace operating module (in fascia panel).

Make sure dispenser detergent door isn't jammed.

Check connections between rinse-aid dispenser, dispenser actuator (a2)

and power module harness connector.

Check dispenser actuator operation while running customer service test

program (steps 15 & 20). If actuator operates, but doesn't open

detergent dispenser cover, replace dispenser. If actuator doesn't

operate, replace power module.

Refill rinse aid, if empty.

Check connections between rinse-aid dispenser (e3) & operating

module harness connector (K12).

Page 47 of 50