- ページ 16

食器洗い機 Bosch DISHWASHERのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch DISHWASHER 28 ページ。 Dishwasher bosch
Bosch DISHWASHER にも： 取扱説明書 (30 ページ), 取付説明書 (34 ページ), 取扱説明書 (30 ページ), 取扱説明書 (28 ページ), 取扱説明書 (30 ページ), 取扱説明書 (38 ページ), 取扱説明書 (42 ページ), 取扱説明書 (32 ページ), 取扱説明書 (36 ページ), 取扱説明書 (30 ページ), 取扱説明書 (24 ページ), 取扱説明書 (26 ページ), 取扱説明書 (40 ページ), 取扱説明書 (28 ページ), 取扱説明書 (29 ページ), 取扱説明書 (28 ページ), 取扱説明書 (28 ページ), 取付説明書 (50 ページ), 取付説明書 (20 ページ), 操作方法 (24 ページ), 操作説明 (36 ページ), 取扱説明書 (25 ページ), 取扱説明書 (46 ページ), 取扱説明書 (31 ページ)

ページを印刷する
Bosch DISHWASHER 取扱説明書
en

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display 8.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).

Timer programming *

T i m e r p r o g r a m m i n g
* depending on model
You can delay
the start of the programme in 1 hour steps
up to 19 hours.
– Switch on the main switch (.
– Press the timer programming
button @ until the digital display 8
jumps to
.
– Keep pressing the timer programming
button @ until the required time
is displayed.
– To delete the preselected starting time,
press the button @ until
is indicated on the digital display 8.
You can change your programme
selection at any time until
the programme starts.

End of programme

The programme has ended
when the value
is indicated on the numerical display 8.

Switching off the appliance

Short time after the end of the programme:
– Switch off the main switch (.
– Open the door.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
16
ã=
Warning
At the end of the programme please open
the door fully and not partially
when emptying the dishwasher. Any
escaping water vapour could damage
sensitive worktops.

Interrupting the programme

– Switch off the main switch (.
The LEDs go out. The programme
is saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes
and then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
– To continue the programme,
switch on the main switch ( again.
T erminating the programme
Te r m i n a t i n g t h e p r o g r a m m e
(Reset)
– Simultaneously press programme
buttons # and 3
for approx. 3 sec.
– The programme sequence lasts
approx. 1 min. On the digital
display 8
– Switch off the main switch (.

Changing the programme

After you have switched the appliance on,
it is possible to change the programme
within 2 min.
If you want to change the programme
afterwards, the appliance waits until
the initiated programme section
(e. g. washing) ends. The remaining time
comprises the remaining time
of the previous programme section
and the remaining time of the new
selected programme.
is indicated.