- ページ 10

食器洗い機 Bosch Integra SHX43C02UCのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Bosch Integra SHX43C02UC 50 ページ。 Bosch integra shx43c02uc: installation instruction

Figure 11

Figure 12

Junction

Box

Cover

Figure 13

Dishwasher Preparation

Plastic Base

Access Panel

Toe

Panel

Remove

Screw

Figure 14

DISHWASHER PREPARATION (continued)

Removing the Toe Panel

Regular Toe Panel

The toe panel is loosely attached with tape. Remove the

tape and pull the toe panel away from the dishwasher. Set

the toe panel aside. It will be reinstalled later.

SHY66C and SHX99A Plastic Base Access Panel and

Toe Panel

The plastic base access panel (select models SHY66C/

SHX99A only) and toe panel are in place on the

dishwasher, but are not attached. Remove the toe panel

first, as shown in Figure 11, then remove the plastic

base access panel, as shown in Figure 11.

Installing the 90° Elbow Fitting

NOTE: The 90° elbow fitting is not supplied with the

dishwasher, and must be purchased separately. If the

dishwasher's hot water supply line is to be copper tubing,

make certain the elbow has a compression fitting.

Apply Teflon tape or other pipe sealant when required.

Orient the hot water supply connection leg of the elbow

toward the channel opening in the dishwasher base. See

Figure 12.

Junction Box Preparation

Remove junction box cover (see Figure 13) by lifting

the junction box cover up and off.

Remove the strain relief plate by removing the screw

at the back of the junction box, as shown in Figure

14 and sliding the strain relief plate out.

Set the junction box cover, strain relief plate, and

screw aside. They will be reinstalled later.