- ページ 2
食器洗い機 Bosch Series 4のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Series 4 10 ページ。 Free standing cooker
Bosch Series 4 にも： 取扱説明書 (24 ページ), 取扱説明書 (44 ページ), 取付・使用説明書 (16 ページ), 取付・使用説明書 (16 ページ), 取扱説明書 (16 ページ), 取扱説明書 (24 ページ), 取扱説明書 (12 ページ), 取扱説明書 (20 ページ), 取扱説明書 (32 ページ), 取付説明書 (12 ページ), マニュアル (2 ページ), クイック・リファレンス・マニュアル (2 ページ), ユーザーマニュアル (16 ページ), 取扱説明書 (50 ページ), ご利用案内 (24 ページ), 取扱説明書 (48 ページ), ご利用案内 (32 ページ), ご利用案内 (32 ページ), ユーザーマニュアル (32 ページ), ご利用案内 (32 ページ), 取扱説明書 (24 ページ), 取扱説明書 (27 ページ), ユーザーマニュアルと設置手順 (40 ページ), ご利用案内 (32 ページ), 取扱説明書 (36 ページ), ユーザーマニュアル (24 ページ), 取扱説明書 (47 ページ), ユーザーマニュアルと設置手順 (28 ページ)
ページを印刷する
Care and cleaning
Only when the appliance is
Installation
switched off.
Dryer housing and control panel
– Scope of delivery: dryer, operating and installation instructions, basket for woollens
– Wipe clean with a soft, damp cloth.
(depending on the model).
– Do not clean with a water jet.
– Check the dryer for transport damage.
– Remove detergent and cleaning agent residue immediately.
– The dryer is very heavy. Do not attempt to lift it on your own.
Exhaust air duct
Exhaust air duct installation instruction
.
– Be careful to avoid sharp edges.
Check the exhaust air duct as it may be clogged.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not set up in a room that is susceptible to frost.
Clean the exhaust air duct at regular intervals, e.g. every six months.
Freezing water may cause damage.
Do not bend the exhaust air duct.
1. Switch off the dryer and allow it to cool down.
– If in doubt, have the appliance connected by a specialist.
2. Disconnect the mains plug.
1.
Setting up the dryer
– The mains plug must always be accessible.
3. Remove the exhaust air duct.
– Ensure that the appliance is placed on a clean, level
4. Clean the exhaust air duct.
and firm surface.
5. Refit the exhaust air duct.
– Install the exhaust air duct
Moisture sensors
installation instruction.
– Keep the area around the dryer clean.
The dryer is equipped with stainless steel moisture sensors.
– Level the dryer using the threaded feet
Moisture sensors measure the moisture level of the laundry.
and a spirit level.
After sustained, repeated operation, a fine layer of limescale
Never remove the threaded feet!
may form on the moisture sensors.
Do not install the dryer behind a door
1. Open the door.
or sliding door which could prevent or
2. Clean the moisture sensors with a damp sponge which has a rough
obstruct the dryer door from opening.
surface.
This will prevent children from locking
themselves in and risking their lives.
Do not use steel wool or abrasive agents!
For mains connection,
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (
same.
– The connected load and necessary fuse protection are specified on the rating plate.
8
Optional accessories
(order from the after-sales service using the order number, according to model)
Exhaust air duct set
WTZ
The exhaust air is extracted via a hose.
1130
WTZ
Washer-dryer stack connection set
11311
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened to the washing machine using this connection
set. If the worktop of the washing machine is less than 544 mm deep, please consult
the after-sales service or your specialist retailer.
WMZ
Platform
20500
For easier loading and unloading. The basket contained in the drawer can be used
Take all accessory parts out
to carry the laundry.
of the drum.
The drum must be empty.
Technical data
Exhaust air duct
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
Weight
approx. 36 kg
Max. capacity
7 kg
Connection voltage
220-240 V
Connected load
2200 W
Fuse protection
10 A
Ambient temperature
5 - 35°C
Product number
Inside of door
Production number
The rating plate can be found on the back of the dryer.
Clean and level.
Consumption rates
Residual moisture in the fabrics
see Safety instructions
page 13.
Fabrics/programmes
Drying time**
after spinning
page 10) must be the
Cottons 7 kg
. Cupboard Dry*
1400 rpm
(50%)
107 min
1000 rpm
(60%)
128 min
800 rpm
(70%)
149 min
Iron Dry*
1400 rpm
(50%)
83 min
1000 rpm
(60%)
99 min
800 rpm
(70%)
116 min
Easy-Care 3.5 kg
. Cupboard Dry*
800 rpm
(40%)
47 min
600 rpm
(50%)
59 min
* Programme setting for testing in accordance with applicable standard DIN EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric, the degree of dryness that has been set
and the amount of laundry being loaded.
Fabrics/programmes
Drying time
Annual energy consumption
Cottons 7 kg / 3.5 kg*
. Cupboard Dry***
97 min / cycle
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
9
After-sales service
What to do if ...
If you cannot rectify the fault yourself (e.g. switching off/on)
What to do if..., page 11/12,
please contact our after-sales service. We will always find an appropriate solution and avoid
unnecessary visits by engineers.
The contact details of your local after-sales service can be found in the enclosed after-sales
service directory.
– GB 0344 892 8979 (Calls charged at local or mobile rate.)
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
Please provide the after-sales service the product number (E no.) and the production number
(FD) of the appliance.
You can find this information:
inside the door* / in the opened service flap*
and on the rear of the appliance.
*depending on the model
Product number
Production number
Trust the expertise of the manufacturer. Contact us for assistance. In this way, you can rest
assured that the repair will be carried out by trained service technicians using original spare
parts.
What to do if ...
Turn the programme selector to Off and remove the mains plug from the socket.
The
Start/Pause indicator light
Mains plug plugged in?
does not light up.
Programme selected?
Check the socket fuse.
Energy
The display panel light and indicator
Energy-saving mode is activated
see the separate
consumption**
lights (depending on model) go out
Energy-saving mode instructions.
and the
Start/Pause indicator
light flashes.
3.16 kWh
The display panel switches off.
The appliance goes into the sleep mode after activating
3.95 kWh
Finished in option
page 5.
4.60 kWh
(Fluff filter/Exhaust air duct)
Clean the fluff filter
page 4.
1.96 kWh
indicator light flashes.
Press the
Start/Pause button to reset the displayed
2.92 kWh
indication and then press the
Start/Pause button
again to restart the appliance if necessary.
3.63 kWh
Exhaust air duct blocked or bent?
Clean the exhaust air duct
page 8.
If necessary, clean the insect screen on the exhaust air
1.32 kWh
pipe.
1.72 kWh
Dryer does not start.
Start/Pause button selected? Door closed?
Programme set?
Programme terminates shortly after
Ambient temperature greater than 5°C?
starting.
Is the appliance loaded with the laundry?
Load too small for selected programme?/Use timed
programme
page 6/7.
Loaded laundry dry?
482 kWh / year
Water is leaking out.
Make sure the dryer is level.
10
11
Safety instructions
The door opens by itself.
Push the door closed until you hear it engage.
Emergency
– Pull the mains plug out of the socket immediately or disconnect the fuse.
ONLY use
– in rooms inside the house.
Drying result is not satisfactory
Warm laundry feels damper than it really is.
the dryer...
– for drying fabrics.
(laundry feels too damp).
The selected programme does not suit the load. Use
The dryer must
– be used for purposes other than those described above.
another drying programme or, in addition, select the
NEVER...
– be modified in terms of its technology or attributes.
timed programme
page 7.
Dangers
– The dryer must not be used by children or persons who have not been
Dryer installed too closely to other objects? Provide
instructed in its use.
adequate air circulation.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
Use
Fine adjust for the dryness levels
page 5.
– Remove all objects from the pockets of garments. Pay particular attention to
Fine layer of limescale on the humidity sensors
cigarette lighters
Clean the moisture sensors
page 8.
– Do not lean or sit on the door
Programme termination, e.g. mains power supply failure,
– Open the door with care. Hot steam may escape.
door open or maximum drying time reached?
Installation
– Fasten down loose leads
Drying time too long.
Clean the fluff filter under running water
page 4.
– Do not operate the dryer where there is a risk of frost.
– The safety information in the separate installation instructions for the exhaust
Insufficient supply of air
Ensure that air can circulate.
air duct must be observed without fail.
Ambient temperature greater than 35°C
Ventilate the
Mains
– Connect the dryer to an AC earthed socket according to specifications,
room.
connection
as otherwise it cannot be guaranteed that the appliance is completely safe.
The humidity in the room
Make sure the room is sufficiently ventilated.
– The cable cross-section must be sufficient.
increases.
Exhaust air duct installed/the exhaust air routes directly
– Only use earth-leakage circuit breakers with the following symbol:
into the open air?
Installation instructions for exhaust
– The mains plug and socket must be compatible.
air duct, page 1.
– Do not use multiple plugs/couplings and/or extension cables.
One or more indicator lights are
Clean the fluff filter
page 4/11.
– Do not touch or hold the mains plug with wet hands
flashing.
Check the installation conditions
page 9.
shock.
Exhaust air duct blocked or bent?
– Never pull the mains plug out of the socket by its cable.
Clean the exhaust air duct
page 8.
Switch off, allow to cool, switch back on, and restart the
– Do not damage the mains lead
programme.
Operation
– Only load the drum with items of laundry. Check what has been loaded before
switching the dryer on.
Power failure.
Remove the laundry from the dryer immediately and
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
spread out. This allows the heat to dissipate. Be careful
grease or paint (e.g. hair spray, nail polish remover, stain remover, cleaning
as the door, the drum and the laundry may be hot.
solvent, etc.)
Risk of fire/explosion.
Condensation in the exhaust air
Exhaust air duct too long? Check the maximum exhaust
– The tumble dryer is not to be used if industrial chemicals have been used for
duct.
air duct length. Further information
Installation
cleaning.
instructions for exhaust air duct.
– Dust risk (e.g. coal dust or flour): do not use the dryer
– Do not turn off the dryer until the drying process ends, unless the laundry will
be removed quickly and spread out, so that the heat can dissipate.
– Do not put laundry containing foamed material/rubber in the dryer
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
– Final part of a tumble dryer cycle occurs without heat (cool down cycle), to
ensure that the items are left at a temperature that ensures that the items will
not be damaged.
– Switch off the dryer once the programme has ended.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer with a faulty mains cable. In order to avoid danger, have
the mains lead replaced only by our after-sales service.
Spare parts
– For safety reasons, you must only use genuine spare parts and accessories.
Disposal
– Dryer: Disconnect the mains plug, then cut the mains cable off the appliance.
Dispose of the appliance at a municipal waste disposal site.
– Packaging: Do not allow children access to items of packaging
Risk of suffocation.
– All materials are environmentally friendly and reusable. Dispose of them
in an environmentally responsible manner.
12
Risk of explosion.
Risk of tipping.
Risk of tripping
Risk of electric
Risk of electric shock.
Risk of explosion.
elastic
Dryer
WTA76200IN
en Instruction manual
13