ページを印刷する
en
Some time after the programme
start a continuous acoustic signal
sounds.
The device does not draw water.
When the door is opened the
message "Check water supply"
is displayed.
Mains water tap is not opened.
Open the tap fully and press the
button M/OK
Then close the device's door for
the programme to resume.
Filter of the water inlet hose is
blocked.
Switch off the device and
disconnect it from the power
supply. Close the mains water tap.
Clean the filter located at the
connection of the Aquastop or the
inlet hose. Finally, restore the
power supply. Open the mains
water tap, switch on the device,
and close the door for the
programme to resume.
Attention
Please remember: Repairs may only be
carried out by professionals.
Unprofessional repairs can cause
significant damage and danger to the user.
28
Downloaded from DishWasher-Manual.com Manuals
of the device.
2
... with the appliance itself
Lower spray arm rotates with
difficulty
Spray arm is blocked by small
items or food remains.
Lid in detergent compartment
cannot be closed
Detergent compartment has been
overfilled.
Mechanism is clogged with
remnants of detergent.
Indicator lamps do not extinguish
after washing has finished.
Remnants of detergent stuck inside
dispenser
Compartment was damp when it
was filled up with detergent.
Compartment must be dry before
detergent is added.
Refill display does not light up.
Rinse aid refill indicator switched
off. (see auto 3in1 chapter)
Salt refill indicator switched off.
(see auto 3in1 chapter)
At the end of the programme there
is still water in the appliance.
The waste water hose is blocked
or kinked.
The waste water pump is blocked.
The filters are blocked.
The programme has not yet
ended. Wait until the programme
ends or terminate the programme.
... during washing
Unusual amount of foam is created
Normal washing up liquid has
been poured into the rinse-aid
container.
Remove any spilled rinse aid with
a cloth as it could otherwise lead
to excessive foaming during the
next washing cycle.