- ページ 7

投影スクリーン Dragonfly DFM-TAB-92のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dragonfly DFM-TAB-92 8 ページ。 Dfm-tab screens
Dragonfly DFM-TAB-92 にも：インストレーション・マニュアル (17 ページ)

ページを印刷する

ADJUSTING YOUR DRAGONFLY MOTORIZED FILM SCREEN

The stopping point for both the upward and downward motion of your Dragonfly motorized film screen can be adjusted easily with the included plastic

Allen key. The screen has 15 3/4" of black material above the screen surface, allowing flexibility for most installations.

"OPEN" Adjustment

This adjustment is made with the screen fully lowered.

1. Insert the Allen key into the keyhole (behind the rubber plug) to adjust the position of the viewing area when the screen is down. Turning the Allen key

1 full revolution clockwise will raise the viewing area approximately ½".

Note: You will not notice a difference of adjustment until you press the 'UP' button and travel the screen several seconds. Then 'DOWN' to see the

difference in screen location.

2. If adjustment has been made too far, turning the key counter-clockwise will "bump" the screen lower. This adjustment can be made with the screen

fully open without raising or lowering the screen.

"CLOSED" Adjustment

FOR REFERENCE ONLY: Closed Limit Switch Adjustment

(Attention: This adjustment is not required. Always contact our Technician for assistance to avoid damaging the screen and

voiding your warranty.)

*ImpORTANT NOTE: IT IS STRONgLY AdvISEd ThAT ThE uSER NOT EvER AdjuST ThE CLOSEd LImIT SwITCh. ALL SCREENS hAvE

ALREAdY bEEN pRE-AdjuSTEd IN ThE FACTORY TO mEET ThE muLTITudE OF uSER NEEdS. dESCRIpTION OF ThIS FEATuRE wAS

INCLudEd FOR ThOSE RARE SITuATIONS ThAT REquIRE IT.

1. Insert the Allen key into the keyhole (closest to back of case) to adjust the stopping point of the motor when the screen is retracted into its

housing. Turning the key 1 full revolution clockwise will cause the screen to stop approximately ½" farther out of the housing.

NOTE: You will not notice a difference of adjustment until you press the 'DOWN' button and travel the screen several seconds. Then press the 'UP'

button to see the difference in screen location.

DO NOT do the following step before step #1 because damage to screen may occur.

2. Turning the Allen key counter-clockwise 1 full revolution will raise the bottom bar of the screen closer to the case approximately ½".

be very careful as you may accidentally retract the screen too far into the case causing damage to the motor and screen.

Adjusting the Tension String

If the string is loose, rotate the String Adjustment Knob clockwise to tighten. If the string is over-tensioned, press the

String Release Button and then rotate the String Adjustment Knob counter-clockwise to suitable tension.

String Adjustment Knob

String Release

String Releasing

Button