- ページ 10
ボート Advanced Elements AdvancedFrame AE1012のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Advanced Elements AdvancedFrame AE1012 19 ページ。 1 person kayak
Advanced Elements AdvancedFrame AE1012 にも： オーナーズマニュアル (20 ページ), オーナーズマニュアル (20 ページ)
ページを印刷する
TM
3.3 Inflating
IMPORTANT: Before inflating, check to be sure that the kayak is completely assembled.
Inflate your kayak in the following order. Failure to follow these instructions may cause
damage to your kayak. Do not over inflate.
1. Partially inflate chamber 1 until the kayak begins to fill out or appears to be half way inflated
then close cap. Check to be sure the valve is in the inflate position (See Figure 1).
2. Inflate chamber 2 until the AdvancedFrame™ tube is firm to touch (2 psi ONLY).
3. Inflate chamber 3 "floor" (using appropriate fitting) twist valve open to inflate and twist
closed when complete. Fill until firm. Do Not Over-Inflate! (1.0 psi ONLY)
4. Inflate Coaming chambers 4 & 5 until firm. Never over-inflate! (1.0 psi ONLY)
5. Inflate chamber 6 & 7 for desired deck lift. Never over-inflate! (1.0 psi ONLY)
6. Make sure all valves are closed tightly and properly.
7. Finally, Insert Plastic Bow and Stern forms into pocket on bow and stern (Figure 3).
CAUTION: Water temperature and weather will affect the air pressure of the kayak. In cold
weather your boat will lose some pressure as the air inside contracts. If this occurs, you may want
to add a bit more air to improve your kayak's performance. However in hot weather, or prolonged
direct sunlight, the air inside will expand. You must let some air out of the appropriate chambers
to prevent the kayak from failing due to overpressure. You should avoid exposing your kayak to
extreme temperatures (hot or cold).
10
Diagram of Inflation Chambers