- ページ 13

ボート Advanced Elements Lagoon1 AE1031のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Advanced Elements Lagoon1 AE1031 20 ページ。 1 person kayak

6. REPAIRS

All kayaks come with a repair kit that includes glue and several patches. This should remain

with the kayak in the event that you may need it. If service is required for your kayak, please call

866-262-9076 for assistance.

1. Cut a rounded patch at least ¼" or ½" larger than the hole or cut.

2. Clean the area where the patch will be placed with water and/or mild soap.

3. Make sure all surfaces are dry.

4. In a well ventilated area, spread a thin layer of glue on both the patch and on the

damaged area. Let it sit for three to five minutes or until tacky.

1. Inflate the PVC tube. Locate the pinhole by sponging soapy water over the tube until

you see air bubbles. Mark the location of the pinhole.

2. Deflate the tube and dry the affected area. Apply a drop of glue to the pinhole

3. Allow glue to dry completely.

4. Do not inflate the kayak for at least twelve hours.

PROBLEM

Does not hold air while

inflating

The kayak is sagging.

The kayak will not hold

full pressure for more

than couple of hours.

The kayak still loses air.

SOLUTION

The spring valve uses a plunger system. The only time the plunger

should be in the open position is when you are deflating. Make sure

that the plunger is closed to inflate. Push the plunger in and rotate

counter-clockwise.

Be sure that the right pump is being used. You need a bellows foot

pump or a double action hand pump. A 12-V electric does not supply

enough pressure to fully inflate the kayak. The 12-V can be used to par-

tially inflate the kayak but one of the other pumps is needed to top it off.

Make sure that the plunger is in the closed position. It should only

be open when deflating. If it is open, the only seal is the black rubber

gasket inside the cap. Even then, a little air may still leak out.

If you have checked all the previous possible reasons for the kayak los-

ing air, then there may be a pinhole or hole somewhere on the tube. Pull

tube from outer covers. Inflate. If you cannot see or hear where a leak

may be, take a clean rag with soapy water and begin rubbing the tube.

If a hole is present, bubbles will continually form. Repair using repair

kit. If it is a very small pinhole, a dab of the glue may be sufficient.

Lagoon1™ Inflatable Kayak Owner's Manual