- ページ 9

洗濯機 Bosch Axxis WFL 2090のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Axxis WFL 2090 36 ページ。 Axxis lavadora
Bosch Axxis WFL 2090 にも：取扱説明書 (37 ページ), 操作およびインストール手順 (37 ページ), 取扱説明書 (36 ページ), (取扱説明書 (37 ページ)

ページを印刷する

About Your Washing

Machine

The washing machine offers the following standard

features:

Horizontal Axis, Tumble Action Wash System,

without agitator

Stainless Steel Inner Wash Drum

Exceptionally Low Energy and Water

Consumption

Internal Heating Element for Power temp.

boost, up to 160 °F (71 °C)

High Spin Speeds, up to 1000 rpm, remove

more water from fabrics to reduce drying time

and energy

4 Fabrics and 5 Temperature Settings

3 special cycles

3 additional functions

Before Using For the

First Time

The washing machine must have been installed

and connected properly (refer to page 26).

Before beginning to use your washing machine for

the first time:

q Make sure the voltage the washing machine

is to operate on is the same as shown on the

rating plate.

q Check to make sure that the water valves to the

washing machine are open.

Using For the First

Time

Your appliance was tested before leaving the

factory. To remove any water left over from testing

procedures, the first washing cycle should be

carried out without laundry in the machine.

q Do not load any laundry.

q Turn on the water tap.

q Open the detergent dispenser to the final stop.

q Pour approx. 1 liter/1 quart of water into

chamber II of the detergent dispenser.

q Fill the measuring cup half full with detergent

and pour into chamber II. Do not use any

special detergents for delicates or wool (to

avoid excessive foaming in the absence of

clothing in the wash).

q Close the detergent dispenser.

q Close the loading door.

q Set the program selector to Power temp.

boost.

The ready control light is flashing.

q Press the Start button.

The wash control light comes on and the

program starts.

i door locked illuminates while the program is

running.

The wash control light changes during the

program to rinse/spin.

When the finished flashes:

q Set the program selector to Off.