- ページ 24
洗濯機 Bosch Nexxt washer OperatingのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch Nexxt washer Operating 26 ページ。
Bosch Nexxt washer Operating にも： 取扱説明書 (37 ページ), 取扱説明書 (27 ページ)
ページを印刷する
Change the light bulb
The dryer light turns on inside the
drum when you open the door.
To change the light bulb:
q
Set program selector to Off".
q
Turn off the circuit breaker.
q
Pull out power supply plug.
q
Open the door and locate the
light bulb on the upper left side
of the seal.
Troubleshooting
d
DANGER
RISK OF ELECTRICAL SHOCK!
Repairs or replacement of parts
may be carried out by authorized
technicians only.
Problem
Dryer does not start.
y
Start/Stop" indicator light does not
ill
illuminate.
i t
Program has been interrupted. Lint
filter" indicator light illuminates,
g
,
a warning signal is emitted and the
display shows E:01".
Degree of drying has not been reached
or the drying time is too long.
y g
g
Display may indicate E:03".
24
Before calling the customer service,
d
check whether you can rectify the
fault yourself by means of the
following table.
If a fault cannot be rectified or
a repair is required:
Possible cause
Main plug not inserted at all or not inserted correctly. Insert main plug correctly.
A fuse of power supply has tripped.
Start/Stop" button not pressed.
No program selected.
Door not closed.
In Time Programs duration not chosen.
Ambient temperature below 41 F/5 C.
Lint filter dirty.
Exhaust air duct is blocked or too long.
Fault in program sequence or malfunction.
The room/cabinet is not adequately ventilated.
Moisture sensor dirty.
Exhaust air duct is blocked or too long.
q
Loosen the screw of the cover
and open the cover.
q
Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
q
Replace the cover and secure
with the screw.
q
Plug in dryer or reconnect
power supply.
1. Set program selector to OFF".
2. Turn off the circuit breaker.
3. Pull the main plug out of the
socket.
4. Call customer service
(see page 25).
Remedial action
Replace/switch on fuse.
Press Start/Stop" button.
Select program.
Close door.
Chose time via Select" Button.
Increase room temperature.
Clean filter as described on page 23.
Switch off/switch on again.
Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 10.
Switch off/switch on again.
Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program.
Provide an adequate supply of fresh air.
Switch off/switch on again.
Clean moisture sensor as described on page 23.
Switch off/switch on again.
Clean exhaust air extraction. Reduce exhaust air duct
to maximum length as described on page 10.
Switch off/switch on again.