- ページ 3

投影スクリーン Draper E SeriesのPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。Draper E Series 4 ページ。 220v ultimate access
Draper E Series にも：設置および操作説明書 (4 ページ)

ページを印刷する

Silhouette/Series E & V by Draper

switches. Always be pre pared to shut screen off man u al ly when new ad-

just ment is being tested. Screen may be se vere ly dam aged if viewing surface

is al lowed to run too far up or too far down.

Adjusting "fully up" position — "Up" stopping position may be ad just ed by

turning the yellow limit switch adjustment socket. The yellow socket is located

on left end of screen roller. Turn ing the socket coun ter clock wise will allow the

view ing surface to retract farther into the case. Turn ing it clockwise will cause

the sur face to stop farther out of the case. One full revolution of the socket will

alter the stop ping position of the view ing surface by ap prox i mate ly 1".

Adjusting "fully down" position — "Down" stopping position may be

adjusted by turning the white limit switch adjustment socket. The white socket

is located on the left end of screen roller. Turning the socket coun ter clock wise

➀ Determine which side requires adjustment.

➁ Secure dowel with one hand.

Caution: Do not touch or bend surface.

➂ Using Philips-head screwdriver, depress spring-loaded adjustment

screw (see drawing) and slowly turn clockwise to tighten tension, or

counterclockwise to loosen tension. The screw adjusts in ¼ turn

increments. Adjust only one increment (¼ turn).

➃ If problem is not corrected, leave screen in position for 24 hours to allow

surface material to stretch into position.

➄ If problem still is not corrected, repeat steps 2 and 3.

Tab-Tension Adjustment Procedure for Silhouette/Series V

Wiring Diagrams for Optional, Built-in Controls

Built-in Low Voltage Control

Junction box at

left end of screen

115 VAC supply

Built-in Video Interface Control

115 VAC supply

Trigger signal

VIC115 (115 VAC, white cord & plug)

VIC12 (12 VDC, brown & orange leads)

www.draperinc.com

will allow the viewing surface to run farther down. Turning it clockwise will

shorten the viewing surface, causing it to stop in a less extended position.

AT NO TIME SHOULD VIEWING SURFACE BE UNROLLED ENOUGH TO

EX POSE ANY PART OF SCREEN ROLLER.

If you encounter any difﬁ culties installing or servicing your screen, call your

dealer or Draper, Inc., Spiceland, Indiana, (765) 987-7999; fax (765) 987-

7142; or e-mail [email protected].

Dowel

Internal screen wiring

White (Neutral)

Black (Hot)

Green (Ground)

Dashed wiring by electrician

Junction box at

left end of screen

Internal screen wiring

Dashed wiring by electrician

(765) 987-7999

Tensioning

Cable

Adjustment

Screw

White (Neutral)

Black (Hot)

Green (Ground)

Page 3 of 4