- ページ 3
投影スクリーン Draper Ultimate Access XL VのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Draper Ultimate Access XL V 7 ページ。 220v electric projection screen
Draper Ultimate Access XL V にも： 説明書 インストールと操作 (7 ページ)
ページを印刷する
Ultimate Access XL E & V
Electric Projection Screen
IDLER END OF CASE
Figure 5
Idler End
Mounting
Bracket
Figure 6
Idler End
Retaining
Clip
Section 4 - Motorized Roller/Fabric Installation
1. Remove bottom access panel
(See Section
Caution: Step 2 requires two people to perform safely.
2. Locate black washer and retaining clips attached to instruction sheet. Lift roller/fabric assembly into screen housing and engage motor head completely into
motor bracket, making sure limit switch adjusting knobs are visible from bottom of screen housing
Please Note: If snap ring is provided, make sure it engages with motor. If retaining clip is provided instead, install to lock motor end in place.
3. Support idler end of roller and slide mounting bracket toward roller. Insert roller pin into nylon bushing on idler bracket.
4. Roller idler pin goes through idler bracket. Reinstall washer and retaining clip.
Caution: Failure to replace washer and retaining clip could result in separation of roller from brackets.
5. Center roller/fabric assembly by sliding mounting brackets left or right.
6. Securely tighten set screws on roller mounting brackets.
7. Connect electrical plug from motor to mating socket on junction box.
8. Attach center door support brackets.
9. Reinstall bottom access panel as previously described.
Section 5 - Motorized Roller/Fabric Removal
Reverse the previous instructions
("Motorized Roller/Fabric Installation")
BOTTOM VIEW
SIDE VIEW
3).
for removal of unit.
MOTOR END OF CASE
BOTTOM VIEW
SIDE VIEW
Motor End
Mounting
Bracket
Figure 7
(Fig.
6).
page 3 of 7
Set Screws
Motor End
Retaining Clip
(Fig. 7)