ページを印刷するRisk of electric shock!
Care
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel
- Wipe with a soft, damp cloth.
- Do not use abrasive detergents.
1.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
2.
... if it contains detergent or fabric softener residue.
1.
Pull out, depress insert, completely remove.
2.
Open the cover.
2* Carefully unscrew pump cover until the detergent solution begins to run out.
3.
Clean with water and dry.
4.
Close and lock the cover (place cylinder on guide pin).
3.
5.
Insert detergent drawer.
4.
5.
Leave detergent drawer open so that residual water can evaporate.
6.
Drum
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling
No washing in the machine!
Descale according to the instructions of the descaling agent manufacturer, not required for
correct detergent dosage.
Information on the display panel
1.
depending on model
2.
3.
4.
F:16
Close the washing machine door properly; washing may be caught.
5.
F:17
Turn on the tap, supply hose kinked/jammed;
6.
clean filter (page 9), water pressure too low.
7.
F:18
Clean detergent solution pump (page 9), outlet pipe/drainage hose blocked.
F:21
Motor fault. Call customer service!
8.
F:23
Water in the base pan, appliance leaking. Call customer service!
7
8
Risk of scalding!
What to do if ...
Allow detergent solution to cool down!
Turn off the tap!
F
Water is running out.
Detergent solution pump
Set programme selector to Off, pull out the mains plug.
F
Water not flowing in.
Detergent not washed in.
Open and remove service flap.
For models with drainage hose:
F
Washing machine door
Take drainage hose out of the holder and pull out of the
cannot be opened.
housing. Remove sealing cap, allow detergent solution
to flow out.
F
Programme does not start.
Press on sealing cap and insert drainage hose into the
holder.
F
Detergent solution is not
For models without drainage hose:
drained.
When the service flap is half full,
F
Washing not spun correctly.
screw back the pump cover and empty the service flap.
Repeat steps until all the detergent solution has run out.
F
Spin cycle actuated several
times.
Carefully unscrew the pump cover (residual water).
F
Water not visible in the drum. - Not a fault - water below the visible area.
Clean the interior, pump cover thread and pump housing (fan impeller in the
F
Residual water in the
detergent solution pump must rotate).
dispenser for care product.
F
Odour formation in the
Reinsert and screw on pump cover.
washing machine.
F
Foam is coming out of the
Insert and close service flap.
detergent drawer.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and select the Drain b programme.
F
Vibrations during spin cycle.
Filters in the water supply
Risk of electric shock! Do not immerse Aqua Stop safety device in water
(contains electric valve).
F
Spin result not satisfactory.
Release water pressure in the supply hose:
Turn off the tap!
F
Display panel/indicator lights
Select any programme (except Spin B/Drain b).
do not function while the
Press Start M. Leave programme for approx. 40 seconds.
appliance is running.
Set programme selector to Off.
Remove hose from tap.
F
Programme progress longer
Clean filter with small brush.
than usual.
Depending on the model, remove hose from the rear
of the appliance and clean the filter.
Detergent residue on the
F
washing.
Connect the hose and check for leaks.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off the tap and call customer service (Installation instructions).
9
Safety instructions
- Correctly attach/replace drainage hose.
- Read and follow the operating and installation instructions and all other information enclosed
- Tighten screw fitting on the supply hose.
with the washing machine.
- Start M not selected?
- Retain documents for subsequent use.
- Tap not open?
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Filter blocked? Clean filter (page 9).
- Never insert/pull out the mains plug with damp hands.
- Supply hose kinked or jammed?
Risk of injury
- Washing machine door may become very hot.
- Safety function active, wait for approx. 2 minutes.
- Caution when draining hot detergent solution.
- L (without final spin) selected?
- Do not climb on the washing machine.
- Start M selected?
- Do not lean on the open washing machine door.
- Door closed?
- Do not touch the drum in case it is still spinning.
- Clean detergent solution pump (page 9).
Risk of posioning
- Keep detergents and care products out of the reach of children.
- Clean outlet pipe and/or drainage hose.
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
- Distribute small and large items of washing in the drum.
of children.
Danger to life
On redundant appliances:
- Not a fault - unbalanced load detection system adjusts
- Pull out the mains plug.
imbalance.
- Sever the power cord and discard together with the plug.
- Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and suffocating.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain
- Not a fault effect of the care product not impaired.
remover/items of washing pretreated with solvent naphtha may
result in an explosion after being loaded into the washing machine.
- Run Æ Cottons 90 ºC programme without washing.
Beforehand thoroughly rinse items of washing by hand.
Use standard detergent.
- Too much detergent used?
Consumption values
Mix 1 tablespoon of fabric conditioner with ½ litre of water
and pour into dispenser II in the detergent drawer.
- Reduce detergent dosage for the next wash cycle.
Programme
Additonal
Load
- Appliance feet fixed?
function
Secure appliance feet (Installation instructions).
- Transportation safety devices removed?
Æ Cottons 40 ºC *
X Wash Plus
7 kg
Remove transportation safety devices (Installation
Æ Cottons 60 ºC
-
7 kg
instructions).
ã Cottons Stains 60 ºC*
X Wash Plus
7 kg
- e Reduced Ironing* selected (page 5)?
Æ Cottons 90 ºC
X Wash Plus
7 kg
(* depending on model)
A Easy Care 40 ºC *
X Wash Plus
3 kg
- Power failure?
A Easy Care 40 ºC
- Fuse tripped? Switch on/replace fuse.
(also suitable as Short
-
3 kg
- If the fault occurs repeatedly, call customer service.
programme)
- Not a fault - unbalanced load detection system adjusts
à Mixed Load
-
3 kg
imbalance by repeatedly distributing the washing.
æ Silk 30 ºC
-
2 kg
- Not a fault - foam control system active - a rinse cycle is
started.
u Wool 30 ºC *
2 kg
- Occasionally phosphate free detergents contain
water insoluble residue.
* Programme setting with Wash Plus X option and maximum spin speed for testing according to
- Select Rinse/Freshen Up á or brush the laundry after
or in accordance with EN 60 456 and IEC 60 456.
washing.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
detergent, fluctuations in the mains voltage and selected additional functions.
10
Washing machine
Operating instructions
Current **
Water **
Programme
duration **
0.65 kWh
65 l
2:30 h
1.20 kWh
70 l
1:35 h
1.19 kWh
49 l
2:36 h
2.00 kWh
75 l
2:33 h
0.55 kWh
50 l
1:24 h
0.55 kWh
40 l
0:55 h
0.60 kWh
37 l
0:50 h
0.25 kWh
34 l
0:32 h
0.15 kWh
30 l
0:40 h
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 11!
11
en