ページを印刷する
- 1. Drill Press
- 2. General Information
- 3. Table of Contents
- 4. Contents/Declaration
- 5. Specification/Guarantee
- 6. Power Supply
- 7. General Safety Instructions
- 8. Additional Safety Rules
- 9. Unpacking and Checking
- 10. Getting to Know Your Drill Press
- 11. Assembly
- 12. Operation and Use
- 13. Operation and Use
- 14. Trouble Shooting
- 15. Optional Accessories
CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (230V)
To eliminate the possibility of an electric shock your machine has been fitted with a BS
approved, non rewireable moulded plug and cable which incorporates a fuse, the value
of which is indicated on the pin face of the plug. Should the fuse need to be replaced an
approved BS1362 fuse must be used of the same rating, marked thus
The fuse cover is detachable, never use the plug with the cover omitted. If a replacement
fuse cover is required, ensure it is of the same colour as that visible on the pin face of the
plug (i.e. red). Fuse covers are available from your Draper Tools stockist.
If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable
should now be suitably prepared and the correct type of plug fitted. See below.
*WARNING:
A plug with bare flexible wires exposed is hazardous if engaged in a live power socket
outlet.
WARNING THIS APPLIANCE MUST BE EARTHED.
The mains lead is coloured Green and Yellow-Earth, Blue-Neutral & Brown-Live. As these
colours may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows. The wire which is coloured green and yellow must be
connected to th terminal in your plug marked with the letter 'E' or by the earth
symbol
or coloured green or green and yellow. The wire which is coloured blue
must be connected to the terminal which is marked with the letter 'N' or black or blue.
The wire which is coloured brown must be connected to the terminal which is marked
with the letter 'L' or coloured red or brown.
EXTENSION LEAD CHART:
Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of tool.
Ampere rating
(on Name plate)
Extension cable length
7.5m
15m
22.5
30M
45M
POWER SUPPLY
3
0.75
0.75
0.75
0.75
0.75
6
Wire Size mm2
0.75
0.75
0.75
0.75
1.25
- 3 -
10
13
1.0
1.25
1.0
1.5
1.0
1.5
1.25
1.5
1.5
2.5
.