ページを印刷するBATTERY CHARGING
To charge the battery pack it must first be removed
from the drill. To release the battery pack squeeze
the grips located on either side of the battery
casing and gently pull the battery pack from the
housing (fig.1). Plug the battery charger unit into a
230V/A.C. 13 amp, three-pin socket. For the
CHD96V, CRD12V, CHD12V, CHD12V2, CHD14V &
CHD14V2 place the battery in the charger as
shown in (fig 2A). For the CHD142V Plus and the
CHD182V Plus place the battery in the charger as
shown in (fig 2B). Do not force. Ensure the battery
is inserted correctly. The indicator light on the
charger will now glow to show that the battery is
charging (fig.3). When the battery is fully charged
the light will go out (approx. 1 hour). The battery
pack can then be removed and used to power the
tool. To refit the battery pack to the drill push firmly
until the battery pack locates and snaps into place.
NOTE:
The battery was discharged after manufacturing
and will therefore require five to ten
charges/discharges before it reaches its full
capacity.
INSTALLING AND REMOVING BITS
This drill is fitted with a keyless chuck, this means
that a chuck key is not required to secure the drill
or screwdriver bit. Place the drill into the chuck as
far as it will go, then hand tighten.
Short screwdriver bits need only be inserted to the
depth of the hexagon shank before tightening the
chuck by hand. Alternatively grip part ✪✌ of the
chuck, (fig.4) and slowly run the drill clockwise
until the chuck grips the bit, then hand tighten.
DIRECTION SWITCH
This switch determines the direction of rotation of
the chuck, i.e. clockwise or anticlockwise.
To alter the direction of rotation, stop the drill and
push ✮✌, (fig.5), switch to the left or right. When
the direction switch is in the 'F' (forward) position
the chuck will rotate clockwise when viewed from
the handle end of the drill. When the switch is in
the 'R' (reverse) position the chuck will rotate
anticlockwise when viewed from the handle. Before
operation check that the switch is set in the required
position. Do not change the direction of rotation
until the chuck comes to a complete stop.
When the drill is not in use move the direction
switch to the neutral position (the middle setting).
OPERATION
Fig.1.
Fig.2A.
Fig.2B.
Fig.3.
Fig.4.
Fig.5.
- 8 -
✪✌
✮✌