- ページ 11
ドリル Draper Storm Force CDH20LI(SF)のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Draper Storm Force CDH20LI(SF) 20 ページ。 18v li-ion cordless hammer drill
ページを印刷する
8.
BASIC CORDLESS ROTARY DRILL OPERATIONS
8.1 REMOVING AND INSERTING BATTERY
PACK - FIG.1)
Locate button on top of the battery pack Depress release
button (A) and slide it out of the base of the drill. After
recharging, insert the battery back into the drill. A simple
slight pressure push will be sufficient.
8.2 CHARGING (FIG.2)
IMPORTANT: Before first use, charge battery for a
minimum of 1 hour.
Connect the battery to the Li-ion 1 hour fast battery charger
supplied. Do not use another battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the drill is switched off by means
of a protective circuit, the chuck will no longer rotate. In a
warm environment or after heavy use, the battery pack may
become too hot. Allow time for the battery to cool down
before recharging.
Plug the charger plug into a suitable mains socket and the
indicator light will show green. The insert the battery pack
into the charger as shown in Fig.2, the indicator light will
become red to indicate that charging is taking place.
a)
Connect the power cord to the charger with a wall
socket. The charger LED will turn green.
b)
Slide the battery as far as it will go into the charger, by
inserting the battery terminal into the suitable opening
of the charger.
c)
The charging LED will turn red, and the three battery
LED's will start flashing continuously from one to
another.
d)
When it reaches approximately 50% capacity, one
battery LED will stay illuminated and the other two
LED's will continue to flash continuously from one to
the other.
d)
When it reaches approximately 75% capacity, two
battery LED's will stay illuminated and the other LED
will continue to flash continuously on it's own.
e)
When charging is complete, all three LED's will be
illuminated for approximately 10 minutes before
switching off.
NOTE: After charging for 1 hour, the battery will be fully
charged. When fully charged, the LED lights will be
illuminated fully green (after 10 minutes approx. these will
switch off). Unplug the charger from the socket as the drill is
ready to use.
8.3 BATTERY LEVEL INDICATOR
By pressing the black button on the rear of the battery pack,
it is possible to identify the amount of charge in the battery.
A single green bar indicates 0-40% charge, two bars indicates
40-70% charge and three bars represents 70% or more
charge. Use this battery level indicator to help plan the
work/job in hand.
FIG.1
FIG.2
11