- ページ 9
ドリル Draper STORMFORCE CSDS20SFのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Draper STORMFORCE CSDS20SF 20 ページ。 Sds+ rotary hammer drill
ページを印刷する
5. HEALTH AND SAFETY INFORMATION
– If no indication appears at all, switch off, remove the battery pack, unplug the charger, check
that the charger contacts and the battery contacts are clean and repeat the process; if there is
still no indication, switch off, remove the battery pack, unplug the charger and check the fuse. If
the fuse is blown, replace and repeat the process; if the fuse blows again, or if the fuse was
intact, attempt no further action. Refer the charger to a suitably qualified person for repair.
Battery packs
– Before charging, read the instructions.
– For indoor use. Do not expose to rain.
– Only use Draper battery packs with stock numbers 89437 and 89433 in conjunction with this
product.
– Do not charge any other manufacturer's battery packs using Draper chargers. Any other
application is considered misuse.
– The battery must be removed from the appliance before it is recycled.
– The charger must be disconnected from the supply mains when removing the battery.
– The battery is to be disposed of in-line with local Authority procedures.
– Do not use any other than the designated Draper batteries/chargers with this product.
– Do not crush, open or burn the battery. Exposure to potentially harmful materials may occur.
– In case of fire use CO2 or dry chemical extinguisher.
– Do not expose to high temperatures >50°C. The battery may degrade at high temperatures.
– Charge battery in conditions between 5°C to 30°C with the specified charger designed for this
battery.
– Do not use battery if it has been stored at 5°C or less. Allow it to "normalise" at room
temperature before usage/changing.
Warning!
● Leaking battery packs
– The electrolyte in battery packs is corrosive. Avoid contact with the skin.
– If contact is made, flush the area with running water, pat dry and seek medical
attention and advice at the earliest opportunity.
– Inform medical personnel that the contaminant is a "high alkaline, corrosive
liquid".
– If electrolyte comes into contact with the eyes, flush with copious amounts of
water only. Seek medical attention immediately, relaying the information above.
5.5 CONNECTION TO THE POWER SUPPLY (CHARGER (sold separately))
– Make sure the power supply information on the charger's rating plate is compatible with the
power supply you intend to connect it to.
– The charger used by this product is designed for connection to a domestic power supply rated
at 230V AC.
– If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow the instructions supplied with the extension lead.
– If using an extension lead, follow the instructions that came with your lead regarding maximum
load while the cable is wound. If in doubt, ensure that the entire cable is unwound. Using a
coiled extension lead will generate heat, which could melt the lead and cause a fire.
– †Double insulated
supplementary insulation is applied to the basic insulation to protect against electric shock in
the event of failure of the basic insulation.
: The charger used by this product requires no earth connection as
- 9 -