- ページ 12

ソウ Draper 36761のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Draper 36761 20 ページ。 360mm bandsaw

ページを印刷する
Draper 36761 取扱説明書
MITRE GUIDE
Most cross cut work, especially with small
pieces of material are more easily controlled
with the aid of the mitre guide
is graduated to 45˚ for assistance in cutting
both left and right hand angles. Fig.13.
RIP FENCE
True straight line rip cutting is best done by
guiding the work against the rip fence
The fence can also be used for cutting off
exact widths. Fig.14.
WARNING: The supporting surface where the
band saw is mounted, should be examined
carefully after mounting to ensure that there is
no movement during use. If any tipping or
walking is noted, secure the workbench or
supporting surface before operating
bandsaw.
CIRCLE CUTTING ATTACHMENT
The circle cutting attachment
the arm of the upper guide block
Accurate circles can be cut out with a radius
of 50mm - 200mm
Make the first cut to the perimeter of the
circle freehand before setting the pivot pin
of the attachment into the work. The pivot
pin must be aligned exactly to the right of the
blade tips. If the pivot is too far back, the
blade will run outside the desired
circumference. If too far forward, the blade
will run inside.
USING YOUR BANDSAW AS A POWER BELT
SANDER
Remove the blade and fit a sanding belt
as explained in CHANGING BLADES
(page10).
However, make sure that the blade support
bearings and the blade guides, both upper
and lower, are well clear of the abrasive
sanding belt. Two sanding stops are available,
one straight and one slightly curved. Screw
the stop into the threaded hole in the
worktable near the table insert with the hex
screws provided with the sanding kit. Adjust
the stop so that the belt just rests against it.
OPERATION & USE
. The guide
mounts on
.
Fig.13.
.
Fig.14.
Fig.15
Fig.16.
- 11 -