- ページ 11

ソウ Draper 55809のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Draper 55809 16 ページ。 350mm (14") chop saw

SERVICE REQUIREMENTS

Brush inspection and replacement.

CAUTION: Before inspecting the brushes,

disconnect the machine from the power supply

BRUSH WEAR AND REPLACING BRUSHES

On new machines check for brush wear after the first

50 hours of use, then every 10 hours.

Replace brushes when they have worn down to

5mm.

Unscrew brush covers ✱✌ Fig.11. Remove brushes

Fig.12. Check for wear or replace. NOTE: When

replacing brushes always replace both brushes.

MAINTENANCE

AFTER EACH USE:

Disconnect the plug from the power supply. Remove the disc and flanges. Wipe deposits of dust from the

housing and guard. Check operation and condition of the lower guard, it should be securely attached and

working properly. The cable and tool should be wiped occasionally with a clean cloth and mild soap only

to prevent deterioration from oil and grease.

CAUTION:

Certain cleaning agents and solvents can damage plastic parts. Some of these are: gasoline, carbon

tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.

Avoiding use of these and other types of cleaning agents minimizes the possibility of damage.

WARNING:

The use of any other accessory not specified in this manual may create a hazard.

WARNING:

Electrical or mechanical repairs should only be carried out by trained service personnel.

Fig.11.

✱✌

Fig.12.

- 9 -