ページを印刷する
5.
HEALTH AND SAFETY INFORMATION
One piece tools
– Clamping screws shall be tightened according to instructions provided by the manufacturer. Where
instructions are not provided, clamping screws shall be tightened in sequence from the centre
outwards.
– Use of loose rings or bushes to "make up" bore sizes on circular saw blades shall not be permitted.
– Use of fixed rings, e.g. pressed or held by adhesive fixing, in circular saw blades or flanged bushes
for other tools shall be permitted if made to the manufacturers specification.
– Resin shall only be removed from light alloys with solvents that do not affect the mechanical
characteristics of these materials.
Repair of tools
– Repair of tools is only allowed according to the tool manufacturers instructions. Particular attention
is drawn to the following.
– The design of composite (tipped) tools shall not be changed in the process of repair.
– Composite tools shall be repaired by a competent person, i.e. a person of training and experience,
who has knowledge of the design requirements and understands the levels of safety to be
achieved.
– Repair shall therefore include, e.g. use of spare parts which are in accordance with the
specification of the original parts provided by the manufacturer.
– Tolerances which ensure correct clamping shall be maintained.
– For one piece tools care shall be taken that regrinding of the cutting edge will not cause weakening
of the hub and the connection of the cutting edge to the hub.
5.5 ADDITIONAL SAFETY INSTRUCTIONS FOR LASER PRODUCTS
– Laser radiation. DO NOT STARE INTO BEAM! Class 2 laser product.
– Viewing the laser output with certain optical instruments (for example, eye loupes, magnifiers and
microscopes) with a distance of 100mm may pose an eye hazard.
– Viewing the laser output with certain optical instruments designed for use at a distance (for
example, telescopes and binoculars) may pose an eye hazard.
– Caution: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
– NEVER direct the beam towards a person's eyes!
– Avoid positioning the laser such that it may lead to
unintentional eye exposure to any potential passing
pedestrians/traffic.
– DO NOT direct the beam towards animals.
– DO NOT use in the vicinity of children.
– DO NOT direct the beam onto reflective surfaces.
– Always switch off when not in use and do not leave
unattended. Remove the batteries before storing the circular saw away.
– This laser product has no serviceable parts. Do not attempt to disassemble or repair.
5.6 RESIDUAL RISK
Important note: Although the safety instructions and operating manuals for our tools contain extensive
instructions for safe working with power tools, every power tool involves a certain residual risk which
can not be completely excluded by safety mechanisms. Power tools must therefore always be
operated with caution!
WARNING: LASER RADIATION – DO NOT STARE INTO BEAM
Maximum Output Power ________________________ 1mW
Emitted Wavelength ____________________________ 650nM
EN60825-1:1994 Safety of Laser Products
- 9 -
Warning!
Laser product
Class 2 LASER PRODUCT