- ページ 18

ソウ Draper BS190のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Draper BS190 20 ページ。 Two wheel bandsaw
Draper BS190 にも：取扱説明書 (20 ページ)

ページを印刷する

MAINTENANCE

CHANGING TYRES

Eventually the rubber tyres on the bandsaw wheels will wear due to the constant contact

of the sharp teeth of the blade. Remove the blade, lift the edge of the tyre with a small

screwdriver and the tyre can be worked off the wheel easily.We recommend that the two

tyres be changed at the same time. (See Spare Parts Listing/Drawing). Refit blade

BLADE GUIDES

Blade guides should be inspected regularly for wear or chipping.When replacing guides

replace all guides at the same time, both upper and lower. (See Spare Parts

Listing/Drawing).

BEARINGS

All bearings used in the construction of your bandsaw and its motor are sealed and

lubricated for life.

CLEAN OUT

Accumulated dust and chips should be removed from inside the bandsaw frequently.

Remove the front cover and use a brush or vacuum cleaner. At the end of every work

session clean sawdust away from the motor vents.

BLADE BRUSH

Ensure that you check on a regular basis that the brush is in full contact with the bandsaw

blade and wheel. This will help to keep the tyres on the wheel clean and assist with the

quick and smooth run down of the bandsaw blade.

NOTE: Bandsaw blade should stop within 10 seconds of the machine being switched off as

per original set up.

OPTIONAL ACCESSORIES

The following accessories are available from your local Draper Stockist:

BANDSAW BLADES

PART No.BB1425

STOCK No.

25760

25761

25762

25765

BLADE WIDTH

6.4mm (

⁄

9.6mm (

⁄

12.7mm (

⁄

12.7mm (

⁄

- 18 -

No. OF TEETH

6 skip

14 TPI

APPLICATION

Wood/plastic