- ページ 4

ソウ Draper BS355AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Draper BS355A 20 ページ。 360mm bandsaw

CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (230V)

To eliminate the possibility of an electric shock your machine has been fitted with a BS

approved, non rewireable moulded plug and cable which incorporates a fuse, the value

of which is indicated on the pin face of the plug. Should the fuse need to be replaced an

approved BS1362 fuse must be used of the same rating, marked thus

The fuse cover is detachable, never use the plug with the cover omitted. If a replacement

fuse cover is required, ensure it is of the same colour as that visible on the pin face of the

plug (i.e. red). Fuse covers are available from your Draper Tools stockist.

If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable

should now be suitably prepared and the correct type of plug fitted. See below.

*WARNING:

A plug with bare flexible wires exposed is hazardous if engaged in a live power socket

outlet.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Green & Yellow - Earth, Blue - Neutral, Brown - Live.

As these colours may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured green & yellow must be connected to the terminal in the plug

which is marked with the letter 'E' or by the earth symbol

green and yellow.

The wire which is coloured blue must be connected to the terminal which is marked with

the letter 'N' or coloured black or blue.

The wire which is coloured brown must be connected to the terminal which is marked

with the letter 'L' or coloured red or brown.

N.B. Three phase machines must be connected by a qualified electrician.

Ampere rating

(on Name plate)

Extension cable length

7.5M

15M

22.5M

30M

45M

POWER SUPPLY

0.75

1.25

- 3 -

or coloured green or

1.0

1.25

1.5

1.25

1.5

2.5